there are some good tips on how to replace OTHER models or years of IAC valves that you can find by googling. However, I tried to take my IAC valve off my 1999 Acura TL and couldn't even get the first bolt out. It's in such an awkward place, you need a philips-head sd and have to come from below, but there's no room to do it. I tried unscrewing it, but couldn't put enough muscle into it and ended up stripping the screw. So then I tried using a simple pliers on it (it's got a round head--no hex-head wrench will do), but that didn't work either. Must have been overtightened when first built. I tried WD-40, but that didn't help either. I will next try either a vicegrips on the screw/bolt. Also, it is probably necessary to remove the entire throttle body assembly first, and then just remove the IAC valve from the TB assembly. I don't think it's possible otherwise, but I'm learning the hard way!
A 1999 Ram does not have a transfer case control module.
The transmission is controlled by the engine computer. It can be replaced.
What is a gem module for 1999 mercury sable? And what does it control?
Where is the lighting control module located on a 1999 Lincoln town car
Need to know which control module. Body, powertrain, airbag, or ABS?
To replace the throttle control module on a 1999 Volvo S80 T6, first disconnect the car battery to ensure safety. Remove any necessary components obstructing access to the throttle body, such as the air intake duct. Then, disconnect the electrical connectors from the throttle control module, unbolt it from its mounting, and carefully remove it. Install the new module by reversing the removal steps, ensuring all connections are secure before reconnecting the battery.
Bulbs cannot be replaced. Entire control module must be replaced.
Possibly, but it's more likely to be a wheel speed sensor.
Pull the cover off the air intake box, unclip the two wires from the old module, remove screws. Screw in new module and replace wores and box. job done
When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.
To change a headlight on a 1999 Acura TL open the hood and locate the bulbs which are plugged into the housings. Loosen the bulbs and pull them off. Replace them.
The Ignition control module is mounted under the hood. It is on the fire wall right beside the hood strut,