how do you replace a honda crv licence plate bulb on a 2004
To replace the license plate light on a 2005 Toyota Sienna, you will first need to locate the light housing on the rear bumper near the license plate. Next, you will need to remove the screws or clips holding the housing in place using a screwdriver or a trim removal tool. Once the housing is removed, you can access the old light bulb, twist it counterclockwise to remove it, and replace it with a new bulb of the same size and wattage. Finally, reattach the housing and secure it back in place with the screws or clips.
Take it to a Buick Dealership
168
who owns vehicle with licence plate ABN 4886
I had to open my trunk, look inside and find butterfly/thumb screws. I un-fastened them and dropped down the entire light bank including the licence plate. One big strip. You can then access the lights from the back of the strip.
How do you change the liscence plate light fuse
In N.Y. State you do. I would imagine that it would be the same in all states as the license plate light makes the license plate readible at night.
bring it to your ford dealer, that's what techs are there for.
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
My owner's manual advises not to attempt to replace licence plate bulb, should take it to dealer to avoid damaging the vehicle, sounds weird but there it is for what its worth. Cheers Ron calgary...
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble