The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.
Replace intake manifold water temp. sensor that's by the thermatstat housing. Next replace your oxygen sensor ---they are 80% of flooding problems,If that fails Check your TBI sensors,egr
The oxygen sensor in a 1988 Cadillac Deville is located in the exhaust manifold. It constantly monitors oxygen levels in the exhaust to allow the engine to operate and peek efficiency.
A "heater" or a "heater core"?
Its a emission Maintenance reminder that advise you each 82,500 Milles that is time to check and replace the Oxygen Sensor and the Counter.
If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
I'm not a mechanic / technician but on a 1988 Ford Ranger there might be ( 1 ) oxygen sensor ( upstream sensor )
The 1988 Honda Accord coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
Chiltons auto manuals have good diagrams, your oxygen sensor is on your exhaust in front of the catalytic converter.
Replace the starter