0
What else can I help you with?
How do you replace a knock sensor on a 2001 daewoo nubira?
How do you flush the transmission fuel from a 2000 Daewoo Nubira
Where is the crank sensor on a 2000 Daewoo matiz?
It is near the bottom of the timing belt in a Chevy. It is part of the ignition system.
Where is the crank sensor located on a 2000 Daewoo Leganza?
Here is a link for a parts place. http://www.partsamerica.com/ProductList.aspx?parttype=985&ptset=A&searchfor=Cam+Position+Sensor
Where is the camshaft position sensor on a 2001 Daewoo matiz?
On the 2000 model it is part of the distributor and you either replace complete distributor or try to dismantle the distributor and replace sensor only.
Where is the crank sensor on a 2000 Nissan Sentra?
where is the crank sensor located on 2000 nissan sentra
Why Daewoo lanos have no spark?
i have a 2000 1.5 auto lanos no spark, good plugs new crank sensor new coil replacement ecu any ideas ?
Where is the crank sensor on 2000 kia sportage 4x4?
crank sensor should always be near bottom crank pulley
Is ckf crank fluctuation sensor and ckp crankshaft positioning sensor same for Honda Civic vtech sport 2000?
No the ckf and the ckp are not the same sensor for a 2000 Honda civic. The crank fluctuation sensor is behind the crank pulley and can be changed fairly easy with some mechanical knowhow when the timing belt is done. The crank position sensor is built into the distributor. To change this sensor you would have to rebuild the inside of the distributor or replace the entire distributor. Hope this answers your question.
Is crank sensor and knock sensor on 2000 villager same thing?
no, it is not.
Where is the oxygen sensor on a 2000 Daewoo nubira?
on the exhuast header pipes
How do you replace a crank angle sensor in a 2000 eclipse?
The 2.4l is located on the right side of the engine. You will see the plug clearly from the top of the engine
Where is the crank sensor on a 2000 Buick LaSabre and how do you replace it?
it's between the Crank pulley and the oil pan.... Right up under the front of the motor. Should just be able to unplug it and replace it. It might have a small bolt holding it in place
