If the correct repair was done it should reset itself after a short drive.
I would unplug the battery. This will reset your clock, etc., but it should turn the light off.
To reset the VSC TRAC light on a 2002 Lexus ES300, first, turn off the ignition. Then, disconnect the battery by removing the negative terminal for about 10-15 minutes. Reconnect the battery, start the vehicle, and the light should be reset. If the light persists, it may indicate an underlying issue that requires diagnostic evaluation.
WERE RESET BOTON LEXUS 300 EX 1996 FUEL PUMP ??
150 you would be safe, could be as little as 75
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
By having a professional repair the problem that has turned the light on. They will reset the light after the repair. This is not a DIY repair.
Depends on which engine warning light you are referring to. If you are referring to the Check Engine light then have the problem repaired that caused it to come on in the first place. They will reset the light. Resetting the light without repairing the problem and it will just come back on.
To reset the throttle position on a 2002 Lexus ES300, first ensure the ignition is off. Then, turn the ignition to the "ON" position without starting the engine and wait for about 10 seconds. After that, turn the ignition off again, and start the engine. Allow it to idle for a few minutes so the system can relearn the throttle position.
Get it serviced
You can reset a maintenance light on a 92 Lexus SC400 by disconnecting the battery. Leave it disconnected for 10 to 15 minutes.
Use your remote control to Unlock, Lock and Unlock again. It worked for my case very well.
The light is on because there is a problem with the SRS. Take it to a professional for repair of the SRS (Air Bags). They will reset the light after the repair. This is not a DIY repair.