To tighten the armrest on a Kia Sedona, locate the screws or bolts that secure the armrest to the seat or the console. Using a suitable screwdriver or wrench, turn the screws or bolts clockwise to tighten them. If the armrest has an adjustment mechanism, ensure it is set correctly before tightening. Always refer to the vehicle’s owner manual for specific instructions related to your model.
on the end that attaches to the side of the back rest there is a zipper. open the zipper, then you can tighten the bolt that holds the arm rest in place. takes about 30 mins & your done. Make sure the arm rest is where you want it as you tighten the bolt.
Flip up the cover on the end of the arm and undo the 12 mm nut. Pry the arm off the wiper motor shaft and simply press new one on. Be careful to align the arm a little past the wiper arm rest and tighten.
prob control arm/ u joint assembly needs to be replaced Wheels not aligned correctly. Tyre inflation incorrect
There is no 2001 Kia Sedona so I changed it to 2002. The 2002 Kia Sedona takes 24" wiper blades on both sides front and a 18" rear wiper. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
No, the rocker arm is not different in a Kia 3.5. The rocker arm is raised and lowered by the movement of the camshaft. The camshaft is what drives the drive cam.
With a screwdriver
Arm, (Arm rest) Leg, (Leg rest)
I had issues with the arm rest coming loose and wobbling and I ended up removing the driver side arm rest and the passenger side arm rest and swapping the two. To remove the arm rest, peel back the velcro at the base of the arm rest, peeling back the cover and revealing the bolt. Then, simply loosen the bolt using a Torx bit size T60 I believe, and that should remove the arm rest.
I had issues with the arm rest coming loose and wobbling and I ended up removing the driver side arm rest and the passenger side arm rest and swapping the two. To remove the arm rest, peel back the velcro at the base of the arm rest, peeling back the cover and revealing the bolt. Then, simply loosen the bolt using a Torx bit size T60 I believe, and that should remove the arm rest.
How much torque do I use to tighten the idler arm
Loosen the top two bolts on the swing arm, after tighten the two bolts on the rear of the swing arm until you have 1.5"-2" of slack. Tighten the top bolts back up and good to go
how do you chang the idel arm