answersLogoWhite

0

The clutch is hydrolic and should adjust automaticly unless there is a leak or air in the line. there is really no way of adjusting it manually

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you change the clutch cable on an 1985 mr2 na?

You have a hydraulic clutch in your mr2, no cable.


How do you change the clutch on a 1989 Toyota MR2 turbo?

Take the trans out, the clutch is inside the trans ^_^


Where would you find a 1985 Toyota MR2 in really good condition?

Some of the names of the websites where you can find a 1985 Toyota MR2 for sale are Cars For Sale, eBay, and Car Gurus.


Does the 1985 Toyota MR2 have air bags?

No it doesn't, not until the 1991 US 1990 European,Japan years did the MR2 have an air bag. There wasn't a 1990 MR2 US Model.


How do you bleed the clutch on a 1985 Toyota MR2?

To bleed the clutch on a 1985 Toyota MR2, start by locating the clutch slave cylinder, which is typically mounted on the transmission. Connect a clear plastic hose to the bleeder valve on the slave cylinder and place the other end in a container to catch the fluid. Have a helper pump the clutch pedal several times, then hold it down while you open the bleeder valve to release air and fluid; close the valve before your helper releases the pedal. Repeat this process until no more air bubbles appear in the fluid, ensuring the reservoir is topped off with fresh brake fluid throughout.


Is a Toyota MR2 faster than a Honda NSC?

The Toyota mr2


What kind of freon does a 1985 Toyota MR2 use?

Would have been built for R12, can be converted to R134a.


I have a Toyota MR2 i was on the hwy going about 70mph i turned off the exit pushed in my clutch to put it in a lower gear and there was no clutch till i pumped it why?

You may have a hydrolic clutch. One that takes fluid to make it work, check your clutch fluid.


What would cause a 1987 Toyota MR2 5 speed transmission not to move at all clutch in or out motor on or off?

Does it go into gear with the engine off? If so, I'd be suspicious of the clutch adjustment.


Where is the drain plug for clutch in 1989 MR2 Toyota?

In the 1989 Toyota MR2, the drain plug for the clutch is located on the transmission housing. To access it, you'll typically need to look for a small bolt or plug on the bottom or side of the transmission unit. It's important to ensure the vehicle is securely lifted and supported before attempting to drain the clutch fluid. Always refer to the vehicle's service manual for specific details and procedures.


Can I get picture view of 1985 4 cylinder 1600 engine for Toyota MR2?

Yes you can. First find someone who has a picture.


What is the book time to change a clutch on a mr2?

My buddy works at Toyota Direct in Columbus, Oh and he said they would charge for about 10 hours of Labor.