0
What else can I help you with?
How do I fix a 2004 ford focus when it has a leaking radiator?
Replace radiator 1-800 radiator or 1-800radiator.com
Can you repair just 1 strut or do you have to do both at the same time on your cadillac?
its always best to do both sides to avoid bad handling problems
How do you replace vw beelte trunk strut?
These are the things that you should have: Screwdriver Hood Prop Trunk Strut And these are some general steps: 1. Open the trunk. 2. Prop open the trunk 3. Remove the retainer bolts from the top and unscrew lower end of the old shocks. 4. Remove the weak trunk strut 5. Install the new strut. Replacing struts in pairs is recommended. 6. Remove prop rod. 7. Inspect and test the trunk to verify the trunk strut repair.
How do I fix a gas leak in a Carburetor on a Kawasaki 220?
1. drive it until you are out of fuel. it will quit leaking. 2. rebuild the carburetor. 3. replace the carburetor 4. identify the reason that it is leaking and then ask another question.
How do you replace struts on a 1995 ford escort wagon?
1. Jack up the front of the vehicle and put it on jack stands. 2. Remove the nuts and bolts that secure the bottom of the strut to the steering knuckle. 3. Remove the nuts at the top of the strut tower and lower the strut assembly out through the bottom. 4. The spring will have to come off as it is not part of the replacement part. 5. To do this you'll have to get a spring compressor. 6. Before you take the spring apart spray the side of the strut assembly with some white paint. Spray a straight line up and down. This will enable you to replace the spring and mounting hardware the way it came off. The spring has to be in the strut to align with the lower housing bracket.
How do you replace the front struts on a 1995 Saturn SL1 and do you recommend replacing anything else in that area while you are in it?
The front struts are held in by (3) nuts under the hood and (2) bolts that hold them to the wheel bearing knuckles. If you have access to a 1/2" pnuematic impact wrench the removal process will take about 5 minutes per strut. You will need a strut spring compression tool to compress the spring and remove the strut mount. I recommend replacing the strut mounts when you replace the struts as the are a wear item. Removing the nut that hold the strut to the strut mount will require a box wrench and a 6mm Allen wrench, put the box wrench on the nut and use the Allen wrench to turn the strut rod. This is also easily removed by the 1/2" pnuematic impact wrench. Reassembly is the reverse of disassembly. You will need to have a wheel alignment performed when you are done as the cast/camber of you tires will be off and will cause severe tire wear. Good Luck
Is it wise to just replace 1 shock?
No, unless it is a very low mileage car and the reason is a leaking top seal. If one shock is leaking in a high mileage car, it means the other shock will also be worn, even if its seal has not leaked. If you replace only one, the damping will be unbalanced from side to side. This is potentially unsafe.
What are the release dates for Toddlers and Tiaras - 2009 Chitlin Strut 1-4?
Toddlers and Tiaras - 2009 Chitlin Strut 1-4 was released on: USA: 17 February 2009
How do you remove and replace the rear shocks on a 1995 Buick Century?
I, too, am trying to change the struts on my 1993 Lasaber. So far I have removed the backseats to get to the top of the strut, but the access hole on top of the strut is too small...it needs to accommodate a 1" socket. Anyone who can take this to the next level would be greatly appreciated.
Will Overwatch 2 replace Overwatch 1?
No, Overwatch 2 will not replace Overwatch 1. Both games will coexist and offer different gameplay experiences.
How do you replace rear struts on 2002 Toyota Avalon?
1. remove rear seat (bottom part of seat pops up and out, bolts hold in top part of seat) 2. chalk front wheels, jack up rear of car on both sides and place on jack stands 3. remove rear wheels 4. remove ABS clip and brake line clip 5. loosen top three bolts holding strut in place under seat (remove insulation flap to find) 6. loosen and remove two bottom bolts on the spindle 7. remove top three bolts holding the strut assembly in place and remove enitre strut assembly. 8. replace bad strut components (will need specialized tools to compress spring) 9. reinstall in reverse order.
How do you replace your rear strut assembly on a 03 grand prix?
I did mine in my driveway using a Haynes Manual for my '03 GTP. It's easy to do but you'll need ratchet style spring compressors available at any aftermarket parts shop and a basic mechanics tool setup (1/2 inch rachets and extensions). Just remember to replace the strut mounts when you replace the struts and don't forget new strut boots (unless you're purchasing a complete strut w/new springs assembly). The job seems daunting but it's really easy, just pick up the manual and you'll get through it with no problems! While you're under there, check out your rear swaybar, rotors and pads. A nice tool to have is an electric or compressor run impact driver (gun), it'll save you lots of knuckle skin and agrivation when working on those old strut mount bolts!
