The oil drain plug torque specification for a 2002 Lexus IS300 is typically around 29 ft-lbs (39 Nm). It's important to ensure that the drain plug is properly torqued to prevent leaks or damage to the oil pan. Always use a torque wrench for accuracy and consult the owner's manual for any specific recommendations.
R134a
every year Is300 transmission will fit. All E-Shift automatics are the same and all W55 5speeds are the same.
YES. Lexus recommends this changed at 90K miles
remove bulb from in side the boot
The starter on a 2002 Lexus IS300 is located on the driver's side of the engine, near the transmission. It is positioned below the intake manifold and can be accessed from underneath the vehicle. To replace or service the starter, it's often necessary to remove components like the air intake and battery for better accessibility.
To remove the front hub assembly on a 2002 Lexus IS300, start by safely lifting the vehicle and removing the front wheel. Disconnect the brake caliper and rotor, then remove the axle nut. After that, detach the tie rod end and lower ball joint, and finally, unbolt the hub assembly from the strut and remove it carefully. Ensure all components are properly supported and refer to a repair manual for specific torque specifications during reassembly.
http://my.is/sign up and you can search the forum lots of good writups
It does not have 1, Chevy did not use a drain plug in there converters.
i have an is300 also and a got a xenon hid kit on my fog lights, they can be replaced , the bulb type is 9006 (hb4)
To locate the solenoid on a 2002 Lexus IS300, first identify the specific solenoid you're looking for, as there are multiple in the vehicle (e.g., transmission solenoid, fuel injector solenoid). For the transmission solenoid, it is typically found on the transmission body, which is located underneath the vehicle. You may need to remove the transmission pan to access it. Always refer to a repair manual for detailed instructions and diagrams specific to your model.
The Suzuki oil drain plug torque specification is 30 pounds. Over tightening the oil drain plug can cause the oil pan threads to strip.
The ECU enhances throttle response and the transmissions shifts a bit more aggressively. It is completely safe for both the engine and transmission.