When the maintenance light turns red in a 1989 Acura Legend, it typically indicates that the vehicle requires immediate attention, often related to critical maintenance issues or services that are overdue. This could involve essential components such as the engine, brakes, or transmission. It's advisable to consult the owner's manual for specific instructions and to address the issue promptly to avoid potential damage. Ignoring the red light could lead to more severe mechanical problems.
my 96 acura 2.5 tl did the same thing, turns out i had a crack in my manifold. this can be welded for about $20 bucks, but labor is about $200.
1-4-2-5-3-6 the distributer turns counterclockwise
HOPE THIS HELPS...ON MY ACURA(TOP-FLIGHT-HONDA) THERE IS A MAINT. REMINDER ON THE DASH THAT TURNS AMBER AT MAINT. INTERVALS. YOU STICK YOUR MAIN IGNITION KEY INTO A RESET SLOT NEAR THE LIGHT, AND THIS TURNS THE LIGHT FROM AMBER BACK TO GREEN. I THINK IT WORKS OFF OF THE ODOMETER ....GOOD LUCK! ..BB
Usually it is pre programmed for oil changes and routine maintenance.
The answer below is the correct answer...I just used it on my 04 MDX. Press and hold the select and reset buttons on the right side of the guage cluster. Turn the ignition to run (II), the light will flash once, then stay on steady. Hold the buttons with the ignition in run until the light turns off.
Has your timing belt been changed? From what I understand, the car automatically turns on the light every 60,000 miles (the recommended interval between timing belt changes). I changed mine well after the light came on (it came on while the previous owner still had it) and the belt was long overdue. Also, when you do change it, you have to manually reset the light.
1-4-2-5-3-6 the distributer turns counterclockwise hope i understood you right.
try e brakes..turn the e brakes on and see if it turns off.if it does then you have suto headlights
The VSA light in an Acura MDX stands for Vehicle Stability Assist. It indicates that the system is actively helping to maintain traction and stability, particularly in slippery conditions or during sharp turns. If the light is on continuously, it may signal a malfunction in the VSA system, and it's advisable to have the vehicle checked by a professional.
To reset the maintenance required light in a 2007 Toyota, first, turn the ignition switch to the "OFF" position. Then, press and hold the trip meter reset button while turning the ignition to the "ON" position (do not start the engine). Continue holding the button until the maintenance light flashes and then turns off. Release the button, and the light should be reset.
put key in keep it in the off position press and hold the trip reset continue to hold turn key to the on position hold trip reset until maintenance light turns of (about 10 seconds)
The present tense of the sentence "She turns the light on" is "She turns the light on."