0
What else can I help you with?
Is there a fuse for code scanner connector for a99 Ford Ranger?
i have a 99 ford ranger xlt. my code scanner connector is not working,is there a fuse for it
Can't retrieve codes on 2001 Ford Ranger with scanner?
Fuse ( # 17 ) is a 20 amp fuse for the cigarette lighter and Data Link Connector on a 2001 Ford Ranger if there is no power
Where is the diagnostic scanner port in a 1995 Ford Ranger?
In a 1995 Ford Ranger, the diagnostic scanner port is located under the dashboard on the driver's side, typically near the steering column. You may need to remove a cover or panel to access it. The port is usually a 16-pin connector, which is used for connecting a diagnostic tool to read trouble codes.
Where is the SPOUT connector on 1997 ford ranger 4.0L V6?
I'm not a mechanic / technician but I believe the spout connector is by your COIL PACK
How do you set the timing on an 1997 ranger with an 4.0 engine?
u need a scanner to set it
What is the spout connector on 1997 ranger 4.0l?
The spout connector on a 1997 Ford Ranger with a 4.0L engine is a diagnostic tool used to set the ignition timing. It is typically a single wire connector that, when disconnected, allows the engine to operate in a mode that simplifies timing adjustments. When the connector is connected, the engine's computer controls the timing for optimal performance. Always refer to the vehicle's service manual for specific instructions on using the spout connector.
How do you change the wiper blades in a 1991 Ford Ranger?
On our 90 Ford ranger the wipers are on a pin arm. Just twist and pull the wipers off the pin. Rain-X makes a replacement wiper, but you will have to change the connector with the other one provided. The first one is removed just by pulling up on the connector. Follow the instructions for putting on the new connector and you will be set to go.
Where is the obd2 connector on a ford ranger pickup 2002?
On the bottom side of the dashboard, in close proximity to the steering column,
Where is the test connector on a 1995 Ford Ranger xlt?
The EEC TEST connection should be in the engine compartment by the Power Distribution Box in a 1995 Ford Ranger ( EEC - IV , OBD I )
Where is the obd2 connector on Ford Ranger?
On a ( 1996 ) and newer Ford Ranger : The Data Link Connector is located in the lower part of the dash , below the steering wheel and between the inside hood release and the parking / emergency brake release . It is BEHIND a small plastic panel that removes ( or maybe flips up )
What do you do about an ABS light suddenly coming on and staying on on the dash of a 2000 Ford Ranger?
Bring to a shop that has an ABS scanner to determine problem
Show me connector 93 ranger?
The Connector 93 is a type of electrical connector used in the Ford Ranger, particularly in models from the early 1990s. It's often associated with various components such as sensors, lights, and other electrical systems within the vehicle. If you're looking for a specific part or diagram, it's best to consult a repair manual or automotive parts supplier for detailed information and visuals.
