0
The exact same place you check the fluid level.
#1, check the service manual (Google it, you can find it for free in a number of places). #2, Get about 4 feet of PVC tubing at the hardware store, along with a funnel that will fit into the end of the tubing. Also, get 2 quarts of Honda Green Label manual Transmission Fluid (MTF) at the dealership. It should be $5-$10 each...depending on how much your local dealership wants to screw you. #3, Get under the car, but make sure that when you jack it up the car remains reasonably level. You can't just jack up the front end like you might when you change your oil. Once you've found the transmission under the car, there are two bolts, a lower and an upper. The lower one is for draining the fluid, the upper is for checking the level and for filling. #4, Get the upper bolt off first. If you can't get it off, you want to know before you get the lower bolt off and start draining. Once you get it off, shove your finger in the hole. You should be able to feel the fluid fairly close to the opening. If you can't, you might have a leak. Once you've done that, put your drain pan down and remove the lower bolt. Let the system drain for a few minutes. #5, Replace the lower bolt. Run your PVC tubing from the top of the engine bay down next to the engine and shove it into the fill hole. Leave the drain pan where it is because you will overflow from the tranny, and you want to catch this. #6, Put your funnel on the other end of the PVC tube and start to slowly pour your fluid into the transmission. Check periodically to make sure that the other end of the tube has not fallen out of the transmission, but it should be fine. #7, The manual says that you should only need about 1.6 quarts, but when I did mine it took almost 2. The point is, you need to keep pouring fluid in until it starts to pour out of the fill hole. You'll catch this overflow in the drain pan, so no worries. Once it's full, replace the bolt in the fill hole (use new crush washers when you do this, and for the drain bolt also...they're the same ones that you use on the oil drain plug). #8, you're done!
What else can I help you with?
Where do you check the transmission fluid in a 2002 RSX?
To check the transmission fluid in a 2002 Acura RSX, locate the transmission dipstick, which is typically found near the back of the engine bay. Make sure the engine is running and the transmission is in park. Pull out the dipstick, wipe it clean, reinsert it, and then remove it again to check the fluid level. The fluid should be within the marked range on the dipstick, and it should be a clear red color.
Where does the transmission fluid go in a 2002 Acura RSX?
Inside the transmission.. their is a filler on the transmission it self.. u need a hose and funnel.. fill it till it spews
Where is the transmission fluid dipstick for a 2002 Acura RSX?
The transmission fluid dipstick for a 2002 Acura RSX is located near the back of the engine bay, on the passenger side. It is typically a yellow or orange handle, making it easier to identify. To check the fluid level, ensure the engine is warm and running, then pull out the dipstick, wipe it clean, reinsert it, and check the fluid level.
How many quarts of transmission fluid does it take to fill a 2002 Acura RSX?
a tad bit less than two quarts
How much transmission fluid does an Acura RSX hold?
2 quarts
Where is the trans dipstick on 2002 RSX?
There is no typical transmission dipstick for this car. The level is checked on an observable reservoir under the hood, on the driver side of the car and fluid is added if needed.
What type transmission fluid does rsx type s take?
The Acura RSX Type S requires Honda Manual Transmission Fluid (MTF) or an equivalent fluid that meets the specifications. It's important to use the correct fluid to ensure optimal performance and longevity of the transmission. Always check the owner's manual for specific recommendations and follow any guidelines regarding fluid changes and maintenance.
How do you change automatic transmission fluid Acura RSX?
To change the automatic transmission fluid in an Acura RSX, first, ensure the vehicle is on a level surface and the engine is warm. Disconnect the transmission fluid drain plug, allowing the old fluid to drain into a pan. Replace the drain plug, then use a funnel to refill the transmission with the appropriate type of new fluid through the dipstick tube. Finally, start the engine, let it run for a few minutes, and check the fluid level, adding more if necessary.
What kind of oil for manual transmission Acura RSX?
For a manual transmission Acura RSX, it's recommended to use a high-quality synthetic or conventional manual transmission fluid that meets the specifications set by Honda. Typically, the Honda MTF (Manual Transmission Fluid) is preferred, as it’s specifically designed for Honda vehicles. Ensure the fluid meets the required viscosity and specifications outlined in the owner's manual for optimal performance.
What is the transmission oil capacity of the 2002 Acura RSX?
The transmission oil capacity for the 2002 Acura RSX is approximately 2.7 quarts (2.6 liters) when using the manual transmission and around 4.0 quarts (3.8 liters) for the automatic transmission. It's important to check the owner's manual or consult with a professional for the exact specifications and any variations based on specific models or conditions.
How do I check the automatic transmission fluid level on a 2003 Acura RSX?
To check the automatic transmission fluid level on a 2003 Acura RSX, start by warming up the engine and then shifting through all gear positions. With the engine running, locate the transmission dipstick, which is typically near the back of the engine compartment. Pull out the dipstick, wipe it clean, reinsert it, and then remove it again to check the fluid level; it should be within the marked range. If necessary, add the recommended transmission fluid through the dipstick tube using a funnel.
Where is the starter solenoid at on a 2002 Acura RSX located?
on the manual, it is behind the engine attached to the transmission, near the passenger halfshaft.
