answersLogoWhite

0

A Hyundai Santa Fe is reported by owners to need adapters when using jacks. The jack stands should be placed as directed by the factory on the jacking points.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Where is the jack in a 2005 Hyundai Santa Fe?

Theres is none!


Where would you place jack stands under a Hyundai tiburon?

There are marks on the frame for this. Either behind the front wheels, or in front of the rear wheels.


Where can you locate the jack in a 2003 Hyundai Santa Fe?

It is in the side compartment of the cargo area.


How do you replace the splash guards on a Hyundai Santefe?

To replace the splash guards on a Hyundai Santa Fe, first, lift the vehicle using a jack and secure it with jack stands for safety. Remove the old splash guards by unscrewing any bolts or clips holding them in place. Position the new splash guards and secure them using the original bolts or clips. Finally, lower the vehicle and ensure everything is properly aligned and secure.


Where is the jack in a 2002 Hyundai Santa Fe?

It is in the trunk in the litle compartment right behind the seat there is a protector and u will be able to find the jack and the latch.


How do you play an iPod in a Hyundai Santa Fe?

If you have the factory installed Monsoon stero, you cannot. Must must but a new stereo that has an audio jack.


How do you removefront CV joint on Hyundai Santa Fe?

To remove the front CV joint on a Hyundai Santa Fe, first, lift the vehicle and secure it on jack stands. Remove the wheel, brake caliper, and rotor to access the axle. Then, use a socket to remove the axle nut and disconnect the lower control arm or strut, if necessary. Finally, slide the CV axle out of the hub and the transmission, taking care to avoid damaging any seals.


What is the best size jack to use for a 2005 Hyundai Santa Fe?

For a 2005 Hyundai Santa Fe, a floor jack with a lifting capacity of at least 2 tons (4,000 lbs) is recommended, as the vehicle's weight is around 3,500 lbs. A low-profile jack with a lift range of around 3 to 18 inches is ideal for easy access under the vehicle. Always ensure the jack is compatible with the vehicle's lift points for safety during use.


Where is the best place to place jack stands 0n a 93 protege?

On the pinch welds, or frame.


Were do you place jack stands on a 91 Chevy s-10?

On the frame rails.


How do to Jack up a 1998 Corvette?

The owner's manual will show you the points to place the jack. I suggest a floor jack and jack stands if you will be climbing under the car.


In the newsies what does jack dream of doing?

Jack dreams of being in a place called Santa fe’ where it’s “clean and green and pretty” as he describes it in the opening number: Santa fe‘ . The place isn’t real however... and it is mentioned multiple times throughout the show.