Your transmission might slip on your ML320 because the Transmission Fluid is low or because the transmission is damaged. The most common cause of transmission slip is wearing of the transmission.
Dexron III will be fine
To remove the transmission from a Mercedes ML320, first ensure the vehicle is securely lifted and supported. Disconnect the battery, then drain the transmission fluid and remove the transmission pan. Detach the driveshaft, electrical connectors, and any linkages, followed by the transmission mount bolts. Finally, use a transmission jack to carefully lower the transmission from the vehicle.
what kind of special transmission oil for 1998 mercedes benz ml 320?
why does the transmission slip or shift hard on a gs Lexus 300 2001
the slip yoke goes into the rear transmission seal
What would make my transmission slip on a Dodge truck when turning left
ofcourse
needs oil refill or the transmission is going to fail
Transmission temp sensor can cause a slip or high rpm before shifting to next gear.
To replace the transmission speed sensor on a ML320, start by disconnecting the negative battery cable for safety. Locate the speed sensor on the transmission, typically near the output shaft or on the side of the transmission case. Remove the electrical connector and unbolt the sensor using a socket or wrench. After replacing it with the new sensor, reattach the connector, secure any bolts, and reconnect the battery.
There's no correlation. The AC won't cause the transmission to slip. If you're having transmission slippage, a bad torque converter is a common cause of it.
The 1999 Mercedes ML320 typically requires about 7.4 quarts of transmission fluid when performing a complete fluid change, including the transmission pan and filter. It's important to check the owner's manual or consult with a professional to ensure the correct amount and type of fluid are used for your specific vehicle.