That is just how the vehicle is wired, its not a defect, its a safety feature, the windows arent supposed to work, unless the ignition is on.
A bad thermostat can cause overheating in a Nissan Frontier when the air conditioning is turned on. A bad compressor can also cause this.
The voltage reg is sticking and will run down the battery.
If your rotors need turned (nowadays it's usually better to replace them, and some can not be turned at all), take them to a shop that has the proper equipment. They can look up the specs.
Sometimes you can have a a pulsation while the brakes are adjusting after you have turned the rotors. You could wait a couple days and see if it corrects itself.
The service engine soon light on a 2002 Nissan Frontier is turned off by turning the key to the on position, pumping the gas 5 times, waiting 6 seconds, and holding the gas pedal down. It is held for 10 seconds, released, and the key removed.
I turned on the ignition in my car. "Houston, we have ignition!"
Could be at least two things - Electrical short - Electromagnetic coupling between power wires for ignition and window/roof motor control wires. Turn on power bleeds onto motor contol lines and induces a electrical current onto the wires causing them to run. Just a guess
That the outlet only has power when the ignition is turned on.That the outlet only has power when the ignition is turned on.
To clear codes on a Nissan forklift, first ensure the forklift is turned off. Then, turn the ignition key to the "ON" position without starting the engine. Press and hold the "Mode" and "Reset" buttons on the instrument panel until the error codes disappear. Finally, turn the ignition off and then back on to verify that the codes have been cleared.
The radio time would stay on if you had the keys in the ignition but the ignition was only turned halfway.
It sounds like your ignition timing timing is too far advanced. It will need resetting.
The ignition system is powered up and ready to run the vehicle.