Drill it. Or call a locksmith and have them do it. They may be able to pull the broken key out.
You broke it.
The key to my ignition broke off in the ignition. Luckily, I was able to insert the remainder of the key in the ignition and turn on my car. In order to fix the problem, I had to take my car to the dealer and I am pretty sure they removed it and installed a new ignition "key hole" keyed to my car. It is a 1990, and I believe the problem happened approx 1993?
Call a locksmith. They have the tools necessary to take the lock apart and pop the key out. Or at least they have the tools to pull the key out - perhaps without taking anything apart.
A locksmith may be able to remove the broke key and make a new one. Or just replace the ignition.
How do I put a New key in ignition into it for 90 mL for speed Baja for Willer I lost my keys
If the key is broken off in the ignition of the 96 Crown Victoria it will have to be picked out. If the key is out and broken, a locksmith can use the broken pieces to make a new key or rekey the ignition.
I propose getting a new key. If you broke it off in the ignition, well, your best chance is to take it to a lock smith or the dealer. Maybe if you take the broken key to the dealer, they can give you a new one. I am not sure on this though.
how do install key ignition switch 1988 Chevy s10
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
Take the panel off by your feet and the one directly under the steering wheel....pull the top panel part up, but you can't take it off because of the steering wheel adjustment handle is in it....turn the key to the on position but don't start it, push the small pin in, located on the bottom of the ignition comonents, pull the ignition guts out......to install, turn the key around until the pin pushes in, put the ignition in, and turn the key back to lock the pin, that is how I did it.
How can I take out the key from the ignition key in a BMW 325i 2001. I can turn on the engine but the key doesn't come out when I turn off.