0
What else can I help you with?
What diagnostic tool can check if your engine is bad?
a human brain is the best.
What is a data port on a ford van?
It is the port, where a diagnostic machine can be hooked up. The diagnostic will read codes from your vehicles computer. For instance if your check engine light comes on, you can plug the diagnostic machine into the data port and it will tell you why the check engine light came on so that you can get it fixed.
Mazda MPV 1992 How do you read diagnostic codes lamp Check engine is ON?
how to reset check engine light on 1992 Mazda mpv
2003 gmc Yukon check engine light comes on what could be the problem?
changed battery engine light stays on
Why did 2005 GMC Yukon Denali temperature gauge is not working?
A non-functioning temperature gauge in a 2005 GMC Yukon Denali could be due to several reasons, including a faulty temperature sending unit, a malfunctioning gauge itself, or issues with the wiring or connections in the dashboard. Additionally, a blown fuse or a problem with the vehicle's engine control module (ECM) might also cause the gauge to fail. It's advisable to perform a diagnostic check to pinpoint the exact cause for accurate repairs.
What do the engine warning light symbols mean on an Infiniti?
have an engine diagnostic check at an auto shop to find out what the problem may be.
How do you reset the check engine light on a 2003 Yukon XL?
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
97 Yukon engine light flashes under load when accerating with no codes what causes this?
A flashing check engine light is usually a misfire.
Where are the engine diagnostic codes located on a 1994 caprice?
In the computer. If check engine light is on you can get them by plugging a reader into port under dash,.
Why 2000 Yukon looses power while accelerating?
If no codes (check engine light) or rpm fluctation first check fuel pressure
Reset check engine light on 2007 GMC yukon Denali?
To reset the check engine light on a 2007 GMC Yukon Denali, you can use an OBD-II scanner to clear the diagnostic trouble codes (DTCs) that triggered the light. Alternatively, you can disconnect the negative battery terminal for about 10-15 minutes, then reconnect it, which will reset the vehicle's computer. However, it's important to address the underlying issue that caused the light to turn on to prevent it from reappearing. If you're unsure, consult a mechanic for a thorough diagnosis.
How do you reset the check engine light on a buick regal?
The check engine light on a Buick Regal can be reset with a special diagnostic scanner. This can be performed at a car dealership or service garage.
