1999 Ford Explorer 4.0 manual transmission gear shifter wont fit on shaft
its iether the fuse // or broken cable //or the gear link on the top back of the gearbox near the gear linkage
The oil is cold in the morning
god no. it may fit but it would shatter soon after
it could be due to the steper motor but i suggest you take it to mechanic because no saxo has ever had a carburetor
To remove the gear shifter knob in a Citroën Saxo, first, ensure the vehicle is in neutral and disconnect the battery for safety. Look for a small cover at the base of the knob, which may need to be pried off gently. Once exposed, locate the retaining clip or screw that holds the knob in place, and remove it. Finally, pull the knob straight up to detach it from the shifter shaft.
Remove drive shaft holder clamps round by the gear box undo off hum get wishbone down and pull drive shaft out
Yes, you can swap a Citroën Saxo gearbox with a Peugeot 106 gearbox, as both vehicles share similar platforms and components. However, compatibility may vary depending on the specific engine and model year. It's important to check for any differences in mounting points, gear ratios, and clutch mechanisms to ensure a successful swap. Always consult a professional mechanic or a detailed guide for your specific models before proceeding.
they are on the ns end cap of the gear box but some dont hav them so you have to drain box and fill through revese light swithch on top of the box (2.3litres)
on the top of the gearbox under the power steering pipes there is a black round plug next to a cable plug if u pull it up then that is where u put the gearbox oil
yes it will any saxo/pug gearbox will fit but putting a 1.4 gearbox on a 1.1 will slow the car down as the gear ratio's in the 1.4 gearbox are longer meaning your cars acceleration will be affected
saxo is good, saxo is reliable..
until the level gets to the maximum on the dip stick ......... aprox 4 liters