Yes, you can swap a Citroën Saxo gearbox with a Peugeot 106 gearbox, as both vehicles share similar platforms and components. However, compatibility may vary depending on the specific engine and model year. It's important to check for any differences in mounting points, gear ratios, and clutch mechanisms to ensure a successful swap. Always consult a professional mechanic or a detailed guide for your specific models before proceeding.
Yes you can, the mountings however are modelspecific.
Yes you can, the mountings however are modelspecific.
The synchro cones in the gearbox are worn. Either a strip and replace or a whole gearbox swap is the cure.
it will fit fine, though you might need to swap the clutch release bearing and the cover plate.
leave it to someone with a garage and a ramp and all the proper tools...it's a nightmare
Yes the transmision/gearbox are both one the same side should be a reasonably easy swap
A Saxo or 106 interior may fit in a Citroën AX, but modifications are likely required due to differences in dimensions and mounting points. While the general layout may be similar, specifics like seat brackets, dash configurations, and panel fittings can vary. It's advisable to check compatibility for any necessary alterations before attempting a swap.
You need to swap the engine and the tranny, use the mounts from the engine mounts from the accent, but the top mount has to come from an elantra 1.8L also, use the computer and wiring harness for the 4g63t. I put a 4g63 in a colt, basically the same car, goes like snot!
The Mitsubishi GTO's twin-turbo 6-speed gearbox is designed for the 6G72 engine, while the 6A12 V6 engine has a different design and mounting points. Although both engines are part of Mitsubishi's V6 family, the gearbox from the GTO is not directly compatible with the 6A12 without significant modifications. In essence, while it may be technically feasible with custom adaptations, it's not a straightforward or commonly undertaken swap.
The S is for sport and then 1st gear. When you swap over to S your gear changing will alter and will take longer to change gears allowing you to go higher up the rev range.
Yes, you can put a VTR gearbox in a VTS, as both models are part of the Citroën and Peugeot family and share similar engine architectures. However, it’s essential to consider compatibility with the vehicle’s electronics, mounts, and final drive ratios. Modifications may be needed for a proper fit and optimal performance. Always consult with a knowledgeable technician or mechanic before proceeding with such a swap.
you need 13mm spanner,undo the lower slider bolt,rotate the cliper upwards,remove the resevoir cap,push the position back,swap the pads and refit. no more than 30min. ;)