First if you have steel wheels you can remove or loosen the center nut (cv axle nut) before jacking up the vehicle, starting by jacking up your Hyundai and properly supporting it. Take off the tire, for the side that your replacing, take out the cotter key on the lower ball joint, remove the lower ball joint nut (sometimes the nut won't come off completely until you break the ball joint loose from the knuckle), use a ball joint separator (fork) to break the ball joint free from the knuckle, pull the lower control arm down until it is free from the knuckle,
To replace the CV joints on a Hyundai Excel, you'll need to lift the vehicle and remove the wheel. Then, take off the brake components and disconnect the axle from the hub. After that, remove the retaining clips and pull the CV joint off the axle. Finally, install the new CV joint, reassemble the components, and ensure everything is tightened properly.
The average cost to replace CV joints is approximately $300. It is more inexpensive and less time consuming to replace both CV joints.
Bad CV joints. Replace the CV joints.
How do you replace the CV joints on a 1993 Nissan Sentra XE?"
It is not cost-effective to attempt to replace just the CV joints. Rebuilt CV shafts are available for as little as $60.
cv joints
On the Chrysler there are no such things as "CV joints". There are however "U joints". To remove them you would have to drop the driveshaft and have them pressed out by a machine shop.
That depends which model it is. On older models CV-joints were moulded into the driveshaft. To be replaced they had to be removed using a press and then warmed to be able to replace them. On these models it is often better to replace the whole driveshaft. On newer models CV-joints are attached with clips and can be replaced more easily.
Maybe it is one of the other cv-joints. Each half shaft has two cv-joints. Better off replacing the complete halfshaft with a rebuilt unit than to replace the one cv-joint only.
The 2000 Ram had u joints, not cv joints at the front axle.
The CV joints in 1999 Malibu can be replaced by removing the front tires and moving the brake lines out of the way. Next, you will need to remove the nuts for the CV joints by using force to remove it from its housing.
To replace the CV joint rubber boot on a Hyundai Accent, first, safely lift the vehicle and remove the wheel. Then, disconnect the axle from the hub and remove the axle from the transmission. Carefully pry off the old boot, clean the joint, and apply grease before sliding on the new boot. Finally, secure the boot with clamps, reassemble the axle, and ensure everything is tightened correctly before lowering the vehicle.