0
- With the key, turn the ignition switch to ON
- Press the SEL/RESET button (on the steering wheel) until the Multi-Information Display presents the Oil Life %
- Hold down the SEL/RESET button for 10 seconds and the display will change to offer an option to reset the Oil Life
- Press the Up/Down Arrow button on the steering wheel until "RESET" is highlighted on the display
- Push the SEL/RESET button and the Oil Life will reset to 100% and the Service Due indication will disappear
What else can I help you with?
How do you reset the maintenance required message for 2008 Acura TSX?
To reset the maintenance required message on a 2008 Acura TSX, start by turning the ignition to the "ON" position without starting the engine. Then, press the gas pedal three times quickly. This should reset the maintenance light. Finally, turn off the ignition and start the vehicle to ensure the message is cleared.
How do you Reset Maintenance Warning Light on a 2008 Toyota 4Runner?
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
How can you reset maintenance light on 2008 sequoia?
Check your owners manual
How do you reset maintenance light on 2008 Saturn Vue?
To reset the maintenance light on a 2008 Saturn Vue, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the maintenance light should be reset. If it doesn't turn off, repeat the steps to ensure the reset was successful.
How do you reset sh-awd light on a 2008 Acura MDX?
To reset the SH-AWD light on a 2008 Acura MDX, start by turning the ignition to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds, then turn the ignition off. After that, start the engine to see if the light has reset. If the light persists, there may be an underlying issue that requires professional diagnostics.
How do you reset maintenance light on 2008 Toyota tacoma?
To reset the maintenance light on a 2008 Toyota Tacoma, first turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the maintenance light should be reset. If it doesn't turn off, repeat the process.
How do you reset the maintenance light on a 2008 civic?
how down the reset button approximately 15 to 20 seconds...then you would notice the maintenance lights flashes. at that time, just press the reset button once more. that's all to it.
How do you reset the oil change light on 2008 mdx?
To reset the oil change light on a 2008 Acura MDX, start by turning the ignition switch to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then back to the "ON" position to verify that the oil change light has been reset. If the light is off, the reset is successful.
How do you reset oil light in 2008 Honda accord?
With the ignition off, push and hold the odometer reset button, now turn the ignition on without starting the engine. After 5 seconds the maintenance required light will go out and reset.
How do you turn off the maintenance light on a 2008 Camry?
Disconect battery for 5 minutes. Disconnect the battery for 5 minutes. Should reset engine light.
How do you reset the oil change light 2008 Acura TL?
With ignition off, press and hold "select" and "reset" buttons, (the ones used for trip odometer). Then turn on ignition, but don't start car, hold until light goes out.
How do you reset change oil maintenance light on a 2008 Dodge Caliber?
Turn on Ignition - depress gas pedal 3 times
