0
major job for the inexperienced
you must first remove the transmission
then you remove torque converter from flex plate. flex plate is equivalent to a fly wheel in a standard gear box
to replace torque converter, is another job in itself as it must be installed loosely until transmission is installed , then properly filled with Transmission Fluid then tightened properly
if not sure about all this, it is likely to not work or fail going down the road
WAIT!, ..unbolt the torque converter from the flex plate and remove with the transmission! If you pull the transmission separately, you risk damaging the pump in the transmission!
Same applies going back in, the torque converter needs to be meshed into the front pump of the transmission before putting into the car. Then once the transmission is bolted to the engine, THEN you bolt the torque converter to the flex plate.
If you do as described in the first answer, you will very likely end up replacing the entire transmission!
This job requires experience and special tools, not for the beginner.
What else can I help you with?
Where is the TCC located on your 2001 dodge Dakota vehicle?
The torque converter clutch is inside the torque converter.The torque converter clutch is inside the torque converter.
Torque converter change on Ford Expedition 1999?
Here is a link regarding Torque Converter http://www.autoshop101.com/forms/AT02.pdf
How do you change a torque converter in 1979 ford f-150?
Pull the transmission and change it. The torque converter is inside the bell housing on the front of the transmission. Only way to get it out is to pull the transmission.
Do you have to remove the torque converter to change a gear box on a Nissan 300zx?
It is best to remove the torque converter to change a gear box on a Nissan. This will help there to be a smoother time adjusting the gear box.
How do you change transmission torque clutch converter on 98 Chevy cavalier?
To change the transmission torque converter on a 1998 Chevy Cavalier, first, ensure the vehicle is securely lifted and supported. Drain the transmission fluid and remove the transmission pan to access the torque converter. Disconnect the torque converter from the flexplate and remove the transmission from the engine, then replace the old torque converter with the new one before reinstalling the transmission and pan. Finally, refill the transmission with fluid and check for leaks.
How do i Drain torque converter in 1998 dodge neon?
You can't. Dodge doesn't have torque converter drain plugs. You have to have the trans flushed to completely change the oil in it.
Where is the torque converter on a 1999 Buick Le Sabre?
The torque converter is between the engine and transmission.The torque converter is between the engine and transmission.
How does a torque converter amplify the torque?
The stator inside the torque converter directs the fluid at an angle to trans. part of the torque converter amplifying the force on the vanes.
Where is the torque converter clutch on a Windstar?
It is inside of and is part of the torque converter.
What is the torque converter ckt performance?
What is the torque converter ckt performance?
How do you change the torque converter clutch on a 1998 Mercury Sable?
The torque converter clutch is inside of the toque converter. You must replace the whole torque converter as an assembly. The torque converter is sandwiched between the engine and transmission inside the transmission bellhousing. To access and replace the torque converter, the transmission will have to be removed. The trnsmission on that car is removed by raising the car on a hoist, supporting the engine with a special engine support tool, removing the lower engine cradle assmebly, and removing the transmission out through the bottom of the vehicle.
Why does your conversion van make a screeching noise when you change gears?
the clutches in torque converter
