0
raise the car, drain the Transmission Fluid, remove any exhaust components that will get in the way of the transmission, remove the starter, remove the drive shaft, remove transmission crossmember, use an engine hoist or a jack to support the engine, remove slave cylinder from bellhousing, remove transmission and bellhousing, unbolt pressure plate, inspect all components replace bad parts, reassemble. DON'T FORGET TO REFILL TRANSMISSION
What else can I help you with?
How much horsepower does a 1994 Camaro 6 speed have?
it is 5000 rpms. (3.4 is the v6 1994 camaro.
Where is the clutch slave cylinder located on a 1994 Chevy Camaro?
should be located on the bell housing
How much horsepower does an 1994 6-speed lt1 camaro have?
275
How do you change the clutch cable on 1994 GMC sierra?
There is no clutch cable its hydrolic.
Does a 1994 Chevrolet camaro z28 have a 3 speed auto box?
No, those were 4-speed autos
How do you change the water pump on a 1994 Camaro?
take it to a mechanic.
Can you change a 1994 Camaro to mamule steering?
"mamule" steering..?
How do you remove The governor in a 1994 camaro z28?
It has no Governor. Speed is computer controlled.
How do you change a 1994 ranger 5 speed clutch?
To change the clutch on a 1994 Ford Ranger with a 5-speed transmission, first, disconnect the battery and lift the vehicle securely. Remove the driveshaft, transmission crossmember, and the transmission itself after disconnecting the shifter and clutch hydraulics. Once the transmission is out, remove the old clutch assembly from the flywheel, clean the surface, and install the new clutch disc and pressure plate, ensuring proper alignment. Finally, reassemble by reversing the disassembly steps, and make sure to bleed the clutch hydraulic system before testing.
How do you change timing belt on 1994 camaro z28?
no timing belt
1994 z28 camaro when you drive the car normally there are no problems but when you slam on the gas the rpms go up but there is no power at the wheelsmeaning im not gaining any speed?
Its probably your transmission slipping if it is an automatic, or your clutch slipping if it is a manual transmission.
Does a 5-speed transmission from a 1994 Ford Explorer fit into a 1991 Ford Ranger without having to change the hydraulic clutch connector on the transmission?
In regards to your question, the clutch assembly should be the same, the only difference mite be the conector for the clutch line which you can change out with one from an explorer then bolt it in and have fun
