To change the distributor cap on a 1996 Mitsubishi Mirage, first, ensure the engine is off and the keys are removed. Disconnect the negative battery cable, then remove the screws or clips securing the distributor cap, and carefully lift it off. Before replacing it, note the position of the wires and their order, then transfer the wires to the new cap, and secure it in place. Finally, reconnect the battery cable and start the engine to ensure proper operation.
To change the distributor cap on a 1996 Impala SS, first disconnect the negative battery terminal to ensure safety. Then, remove the wires from the old distributor cap, taking note of their order for reassembly. Unscrew the cap from the distributor, replace it with the new cap, and reattach the wires in the correct order. Finally, reconnect the battery and start the engine to ensure proper function.
The distributor cap is located on the top of the distributor on a 1996 Sunfire. It is connected to the spark plugs via a wire.
1,3,4,2
buy a new distributor cap and rotor. Unscrew the distributor cap (on the drivers side of the engine block), take note how the existing rotor is sitting, remove it, and place the new rotor in the same position. Put on the distributor cap and screw it into place... very simple job. thats how you change the rotor......he asked about the distributor....try again.
It's the distributor rotor that you are looking for & it's under the distributor cap. Remove the distributor cap and there you will find the rotor.
the bolts holding the distributor cap is a 7mm
There are two screws that hold it to the distributor.
Inside the distributor with the ignition coil, cap and rotor
There is no "chip" that can be replaced in the distributor, it is serviced as a unit. There is no chip in the distributor cap.
a junk yard
yes
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.