0
To install the serpentine belt on a 2001 Pontiac Montana, first, ensure the vehicle is turned off and the battery is disconnected. Locate the belt routing diagram, usually found on a sticker in the engine compartment. Use a wrench to relieve tension on the tensioner pulley, then slip the new belt over the pulleys according to the diagram, ensuring it sits properly in the grooves. Finally, release the tensioner to secure the belt, double-check the alignment, and reconnect the battery.
What else can I help you with?
How do you replace the serpentine belt pulley on a 1997 Pontiac Montana?
it is a 2001 Pontiac Montana that has broken three bealts so far I need to know what pully I will need to replace?
2001 Pontiac Montana overheating?
2001 Pontiac Montana?
How much refrigerant is needed to recharge AC on a 2001 Pontiac Montana?
How much refrigerant is needed recharge ac on a 2001 Pontiac montana
2001 Pontiac Montana Radiator?
yes it has one
Where is radio fuse located in 2001 Pontiac Montana?
No
Where is the vacuum modulator on a 2001 Pontiac Montana?
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
Does the 2001 Pontiac Bonneville 3.8L V6 have the single serpentine belt?
yes
Where is the ECU on the 2001 Pontiac Montana?
under the antifreeze compartment
How do you replace a starter on a 2001 Pontiac Montana?
Remove the wires from the starter. Remove the retaining bolts. The starter will easily come out. Reverse the process to install the new starter.
Where is the block heater cable on my 2001 Pontiac Montana?
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
How many fuel pump fuses on Pontiac Montana 2001?
There is only one fuel pump fuse on a 2001 Pontiac Montana. It can be found in the engine compartment near the firewall at the rear of the compartment.
How do you change a radiator on a 2001 Pontiac Montana?
Before changing the radiator on a 2001 Pontiac Montana the coolant must first be drained. After the drain remove the radiator mounts, fans, and hoses. Pull the radiator upwards.
