To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
Depending upon what year, it is typically under the rear seat on the driver's side. You should disconnect the negative terminal on the battery first and then remove the seat cushion bottom from the driver's side rear seat. Depending upon what year, it is typically under the rear seat on the driver's side. You should disconnect the negative terminal on the battery first and then remove the seat cushion bottom from the driver's side rear seat.
On newer models, you have to move the seat all the way forward, remove side trim cover, remove seat belt anchor bolt, remove seat rails retaining bolts, tilt seat upward, disconnect wires, remove seat...
I have done this on a 2009 Outback: Passenger side: Slide seat back remove two bolts in the front then slide seat forward and remove two bolts in back. Tip seat backwards to remove any cables for heated seat. I did not do the driver's side but looks the same except probable more wires for the power seat.
How do you remove the driver s seat from a1997 mercury villager
1993 kawasaki voyager motorcycle how do you remove the driver seat?
I have a 2000 Contour and there was a 19mm stud between the armrest and seat. It is hard to see and get the wrench on.
there is a box under the driver's seat in Sentra 2003. What is it for?
There are many: 1) In front of rear seat Remove carpet at the bottom front of both passenger side and driver's side 2) Under hood driver's side 3) Under instrument cluster driver's side
Most likely the same way you remove any bucket seat in a car. 4 bolts holding the seat rails to the bottom of the car, and if it's an electrical seat, an electrical wire plug.
If you raise the car up on that side (safely) you should find four bolts that hold the seat and track in place. You will need to remove those bolts.
Remove the nuts! They are on the lower metal frame the seat