0
there is a tool yo do it or you can use a very small screwdriver to pull the retaining wire out. be carefull not to bend it so much that it permanitly distorts. then the line just pulls out. all the wire does is hold the line in place there is a bulge in the line that it catches on then an o-ring that makes the seal. one last note if you have to replace the Transmission Fluid use atf+4 or you will destroy it.
What else can I help you with?
How do you remove the quick connect on the transmission line of a Chevy s10?
There is a plastic fitting or tool that goes around the line and you push into the fitting to release it. Push it in and pull out the line. You can buy a set of 5 for around $8 to $10 U.S.
How do you remove quick disconnect transmission line on a jeep?
Easy use a quick disconnect tool or a small screwdriver
How do you remove the transmission cooler lines from the transmission on a 1992 Jeep Cherokee Loredo?
The bottom fitting is a quick connect fitting. You usually use a special tool to release this fitting. Some auto parts stores will lend you the necessary tool for free. The top line will be a flare fitting, which will require the proper sized end wrench or line wrench to remove.
How do you loosen transmission cooling line which connects to the radiator on a 2000 Chevy impala?
There are quick connect clips on that fitting. simple use a screw driver to press up on the side of the clip and you should be able to remove it. then the lines just pop out.
How do you disconnect the transmission fluid cooler lines from the transmission on a 1992 Jeep Cherokee?
Those transmissions have whats called a "Quick Connect" fitting. There are little plastic tabs on the fittings that must be pushed in so that the line can be pulled out.
Where is the slave cylinder 97isuzu hombre?
Remove trans to replace slave....Slave is connected directly to throwout bearing in bellhousing... shoot yourself because your new slave cyl is now in the transmission bell houseing and your quick connect hydro line will not fit your newly installed slave cyl. unles you can hand machine that connector ( I did) you will hlf to do the whole proses again may as well put it on the moon,good luck finding replacement for quick connect hydro line
Where can I purchase a 10' gas line with quick connect to connect my small bbq grill to my RV gas line?
Camping World for like 40 bucks
Could it be dangerous to connect an alternator to a long transmission line if the line had a high capacitance?
Yes. Because... If we connect an alternator to a transmission line of high capacitance the line voltage will increase and caused a line voltage difference, which does not satisfied the condition of parallel operation of same voltage rating. [By Akhtaruzzaman08]
Where does transmission vacuum line connect?
The Vacuum line usually connects to the brake booster , or atleast it does in my Ford explorer
How do you remove heater hose conecters on silverado?
GM Heater Line Quick-Connect Release Tool this will do it. Otherwise you need to try and use a hacksaw to cut it off, though I wouldn't recommend it, might cut the line into the heater coil
There is a top bottom transmission line on the radiator and a front and rear connection on the trans where does the top line from the radiator connect on the trans front or back?
upper line on radiator connects to transmission front
How do you remove the hydralic line from clutch slave on 96 Chevrolet pickup?
Some of these come as a pre-bled, pre-assembled set with master, line and slave. GM loved this for a while. If the line is removable it will either detach like a quick connect fuel line of will be threaded together. Good Luck
