Open the hood,remove air filter box and look to the right near the end of the trans axle is where the sensor is,remove the connector with two wires in it.then remove the sensor.
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
The input and output speed sensors are located on the front of the trans. They have two wires and the input sensor is closer to the engine.
The speed sensor on a 1990 Chrysler Voyager is typically located on the transmission. It is often mounted near the output shaft or on the side of the transmission housing. To access it, you may need to lift the vehicle and remove any components obstructing the sensor's location. Always consult the vehicle's service manual for precise information and guidance.
If you are refering to the vehicle speed sensor (VSS) it is on tranny by where the axles are
the speed sensor senses the speed and tells your transmission when to shift , it also controls your speedometer.
The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.
we had to replace the speed sensor in mine and it corrected the problem with the speedometer and the shifting. Good luck
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
there are 2 sensors. if your speedometer is inop replace the output speed sensor in trans drivers side. both look the same output is the one towards the rear.
Probably 60 miels per hour.
The Speed Sensor (for 2.5 V-6) is located in the Transmission housing Drivers side behind the Dipstick Oil tube under the Distributor (hard to see!), you must remove the tube in order to access the sensor or replace it. It is a Cylindrical sensor with a tab on it for screwing it to the transmission, screw holding it is a 10mm.
how do you replace a 2004 buick rendezvous input speed sensor