THE timing on a 88 Comanche w/inline six cyl. is set at the factory and not adjustable.
how do you set timing on 88 s10 2.5? ?
To set the timing on a 1989 Olds 88, first ensure the engine is off and at operating temperature. Locate the timing mark on the crankshaft pulley and the timing scale on the engine. Use a timing light connected to the number one spark plug wire, then start the engine and point the light at the timing marks. Adjust the distributor until the timing mark aligns with the specified degree on the scale, then tighten the distributor hold-down bolt and recheck the timing.
To set the timing on an Oldsmobile Delta 88, first ensure the engine is at operating temperature and then turn off the engine. Locate the timing mark on the harmonic balancer and the timing tab on the engine. Using a timing light, connect it to the battery and number one spark plug wire, then start the engine. Adjust the distributor until the timing mark aligns with the specified degree on the timing tab, usually indicated in the vehicle's service manual.
The 1988 Chevrolet Celebrity uses idistributorless ignition systems, the timing is controlled by the ECM. there is no provision for adjustment.
How to change a timing chain in a 1998 Oldsmobile delta 88
There is a plastic line across from how it was made on the cap and you want your timing place to the left just a little bit behind from what they call #1
what timing are you trying to set? the cam timing or the ignition timing?
facotry is set at 0 TDC but a 6-8 degree andvance will improve MPG's and more power, must run 91 octane if timing is set more then 2-3 degrees BTDC
Timing is set by the PCM and not adjustable.
Ford V-8 engines do not have timing belts.
separate a timing connector on the firewall in engine bay which allows you to time the engine,then adjust the distributor.The connector is on the drivers side below the cowl and when separated the engine will run differently.