I'm assuming you mean spark plug wiring, in which case, one of the most important things to find out is your particular motor's firing order. You can locate this information on line or invest in a manual. Pay close attention to the routing of your wires, especially adjacent cylinders, make sure the wires do not touch or are too close together else crossfiring could occur.
The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.
where does the hot wire come from going to the distributor on a chevy 350
To wire a Prestolite distributor, first ensure the ignition is off and the battery is disconnected. Connect the primary ignition wire from the ignition coil to the terminal marked "B" on the distributor. Then, connect the secondary wire from the distributor cap to the ignition coil's output terminal. Finally, ensure that all connections are secure and that the distributor is properly grounded before reconnecting the battery and testing the ignition system.
The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.
Yes
It is a brown wire connected to the distributor.
Maybe try putting the distributor wire back on and see if the jerking stops.
Assuming you have an older vehicle with points, the wire from the distributor goes to the neg side of the coil.
what is the plug wire placement on the distributor cap of a1996 gmc 4.3 v6?
You can not, it is a complete different type of Distributor. And engine will not run
green
That is the location of wire #1