answersLogoWhite

0

Typically, a starter motor is secured with two to three bolts, depending on the specific vehicle make and model. It's important to consult the vehicle's service manual for the exact number and specifications, as this can vary. Always ensure that you use the correct tools and torque settings when reassembling to avoid damage.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How many bolts on a starter in a 1986 Oldsmobile cutlass supreme?

There are 2 bolts that hold the starter in place and 2 nuts that hold the wiring to the solenoid.


How do you replace the starter on a Chevy Tracker?

how many mounting bolts hold 2002 chevy tracker starter in place


For a '97 Dodge neon - When changing a starter how many bolts need to come out and what size are they?

there are only 2 bolts one on top and one on the bottom assuming that you have removed the wires (there is a small 5mm bolt the holds a connection to the starter, the bolts that actually hold the starter on are 15mm i believe.


How many bolts holds your transmission to your motor 91 acura integra?

i think 6 with the long 14" starter bolt


How do You replace the starter on a 1989 buick park avenue After remove the bolt the starter don't move Where the bolts are located and how many must be removed. Any picture available?

There are at least two bolts on the front and sometimes there is one that holds the back up .


How many bolts on a starter for 85 celebrity?

Two bolts hold the starter to the block. There may also be a brace on the other end of the starter.


How many bolts are there on the starter of a 1995 dodge stratus?

2 bolts


How many bolts are on a starter of a 1985 Nissan pickup?

2 bolts


How many bolts in a Dodge Intrepid starter?

Three bolts hold it to the engine.


How many bolts in 2000 Mercury Sable starter?

The 2000 Mercury Sable starter will have three retaining bolts. There will be two cable retaining nuts on the front of the starter.


How many bolts does the starter has?

Starters are usually held on by 2 bolts. Sometimes 3.


How many bolts hold the starter on your 1988 B2000 pickup?

2 bolts hold it on

Trending Questions
What do a checkbook tire and a scale have in common? How do you unlock the ignition switch on a 2000 dodge neon? How do you remove the cv joint from the transmission of a 90 Nissan Sentra? Can you replace a rejection Base Socket in fuse box? What car does bosch oil filter 3334 fit? What kind of spark plug for a Yamaha pw 80? Is a clutch replacement on a 1995 Nissan Sentra difficult or not too bad? Does a 1995 Camaro Z28 have a blown head gasket if antifreeze is blowing smoking out of the tailpipe but is not mixing with the oil and if so do you have to drop the engine to fix it? What are filters used for? I walked into my grandpas apartment and saw two crossed arms like a X and then I turned around and a completely burned man pushed me down and started screaming no noise was coming out? What does 70Ah battery mean? What can cause the change oil light to come on then go off? How did the diesel engine get its name? 2004 Trailblazer. Checked the code and the problem was the engine coolant temp sensor just replaced the part and engine light came on again checked the code and said it was the same part any help? What are the uses of overdrive and when should it be used? Does not too distant future need hyphens? Your 1996 lumina wont start you pulled the fuel filter off and turned over the engine and no fuel would that mean its the fuel pump? What size door speakers are in a 2002 ford ranger ext cab? Are exhaust manifolds the same for 350 olds and 455 olds? Does tire rotation fix tire feathering?