0
If you go to a normal shop, the parts are rarely the issue. Clutch jobs run from $600-800 depending on the reputability of the shop and the area of the country you are in. Always check the warranty or lack thereof. They will always make up charges to get it up as close as they can to $1000, no matter if it is a Subaru, Saab, or chevy.
There will be shop fees, energy fees, disposal fees, tax, and labor at $90/hr or better. If you really want the listed labor rate go to alldata.com, get a membership, and get the actual hours of labor for the job. If they charge more hours than in alldata, go to a different shop. These are standards based on the make of the vehicle. Make sure they itemize all charges before you take the car in.
Also, BE SURE TO CHANGE THE THROW OUT BEARING. If it is integrated into the clutch slave cylinder, replace with a NEW ONE. Make sure you specify NEW hydraulic clutch fluid in the entire system. If it is a cable clutch, change the cable too. You will kick yourself later if you do not replace all the components at this time. Also, make sure the flywheel is resurfaced professionally, not just a brillo pad on a drill. Pilot bearing has to be replaced too.
What else can I help you with?
Why is the clutch on your 1998 subaru legacy outback stuck to the floor?
Your clutch cable snapped. It should be an easy fix.
How do you replace a radio on a 1998 Subaru Outback?
take out the old one and put in a new one.
What is the cost to replace a backup light relay switch in a 1998 Subaru Outback with a manual transmission?
S100
Will a Subaru 1996 outback radiator fit in a Subaru 1998 outback?
Will fit Legacy/Outback Model Year 1995 to 1999.
How do you replace the rear bumper on a 1998 Subaru Outback?
Take the old one off, and install the new one. Dick.
1998 Subaru Outback Why are the emergency brake and battery message lights on?
The alternator is overcharging due to the regulator malfunctioning. Replace the alternator.
How do you replace the clutch slave cylinder on a 1998 subaru legacy?
remove the old one and install a new one.
Is a 1997 subaru legacy outback transmission the same as an 1998 subaru sus?
It should be.
What oil weight for a 1998 Subaru legacy outback?
5w30
How do you change a knock sensor on 1998 Subaru Outback?
that the knock sensor does
How do you replace automatic transmission fluid in 1998 Subaru Outback?
Pull the dipstick out, put a funnel into the tube where the dipstick was, open transmission fluid container, pour.
How do you replace expansion valve on a Subaru 1998 Outback?
To replace the expansion valve on a 1998 Subaru Outback, first, ensure the A/C system is fully discharged by a professional to avoid refrigerant exposure. Remove the dashboard or center console components as necessary to access the A/C evaporator. Disconnect the refrigerant lines from the expansion valve, unbolt the valve from its housing, and replace it with the new one. Finally, reassemble all components and recharge the A/C system.
