answersLogoWhite

0

No, a 500mA fuse is not the same as a 5A fuse. The 500mA fuse can handle a maximum current of 500 milliamperes, while the 5A fuse can handle up to 5 amperes, which is ten times the current of the 500mA fuse. This means that the two fuses are designed for different current ratings and should not be used interchangeably.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

What happen when a 3A fuse replaces a 5A blown fuse?

The device will work, but the 3A fuse will blow quicker than the 5A would have.


Which fuse controls the stereo in a 2002 Ford Expedition Eddie Bauer?

F1 is a 25A fuse and it is listed as audio F8 is a 5A fuse listed for the Radio F20 is a 5A Fuse listed as audio


What size fuse does the reverse lights take?

5A


Can you use a 1.5a 125V fuse to replace a 5a 125V fuse?

No, it is not safe to replace a 5A fuse with a 1.5A fuse. The fuse rating must match the current requirements of the circuit to avoid overheating and potential fire hazards. It is important to always replace a fuse with the same or higher current rating as specified by the manufacturer.


Are the dash light on 1999 mustang controlled by and fuse and if so which fuse works them?

There is a 5A fuse #21 and 15A fuse #5.


What is the correct size of fuse to be fitted in the connection unit of a fused spur supplying a 1kw lighting circuit?

1000w/230v= aprox 5A


What does the value of a fuse mean?

The value of a fuse shows how many volts of electicity it will allow to pass through until it cuts out. For example a fuse saying 5A will allow anything up to 5A to pass through but if any more than that flows into it, the fuse will cut out.


What happens when a 250V 2500W water heater is connected to mains supply with a 5A fuse?

When a 250V, 2500W water heater is connected to a mains supply with a 5A fuse, the fuse will likely blow. This is because the heater draws approximately 10A (calculated by dividing the power, 2500W, by the voltage, 250V), which exceeds the 5A rating of the fuse. As a result, the fuse will interrupt the circuit to prevent overheating or damage, preventing the water heater from operating.


What size resistor do you need to reduce a 6 volt 7.5 watt 500 milliamp trickle charger to a 4 volt charger of the same size?

Reducing 6 volts to 4 volts at 500ma trickleThe formula is voltage / current6v-4v=2v / .5a = 4 ohmspower = current squared x resistance or voltage x currentpower of R = .5a x .5a x 4 ohm = 1 watt minimumor 2 volts x .5 amps = 1 watt minimum


What does 500mA equal to?

500mA = 500 miliamper 1000mA = 1 amp so 500mA = .5 amps


Can a 10a fuse replace a 5a fuse?

No, a 10A fuse should not replace a 5A fuse. Fuses are designed to protect circuits by breaking the connection when the current exceeds a specified limit; using a higher-rated fuse can allow too much current to flow, potentially damaging the circuit or causing a fire. Always replace a fuse with one that matches the original rating for safety.


What is the fuse number for the horn on a 2002 Lincoln LS?

Under the hood...Fuse number 4. Needs a (5A). Hope that helps.