0
What else can I help you with?
What is the wiring diagram for a 1989 Honda CRX for a Sony Xplod CD player model number cdx-gt52w?
To wire a Sony Xplod CD player (model CDX-GT52W) in a 1989 Honda CRX, you'll typically connect the power wires as follows: the red wire (ignition) to the car's accessory power, the yellow wire (battery) to a constant 12V source, and the black wire (ground) to a solid metal ground point. For the speaker connections, match the speaker wires from the CD player (usually color-coded) with the corresponding wires from the car’s harness. It's always best to consult a wiring diagram specific to your vehicle and the CD player for precise connections.
What is the wire diagram for a sony xplode CDX-GT500?
The wiring diagram for any Sony electronic equipment can be obtained from a Sony electronics distributor. The diagram can also be found at most electronic stores.
Were does the remote wire on a Sony Xplod amp go?
the remote wire goes into the back of the deck (head unit). it tells the amp to turn on when the deck is powered up, if you don't connect it it will continue to drain power from your battery.
How do you bridgd 4 channle sony xplod 500 watt amp?
To bridge a 4-channel Sony Xplod 500 watt amp, first ensure the amp is powered off. Connect the positive speaker wire from the left channel (positive) to the positive terminal of the subwoofer, and the negative speaker wire from the right channel (negative) to the negative terminal of the subwoofer. Set the amp's switch to 'bridged' mode, if available, and adjust the gain accordingly for optimal performance. Always consult the amp's manual for specific instructions and wiring diagrams.
Where is a Wire harness diagram for sony xplod CDX-4000x?
http://www.iq.sony.com/SRVS/CGI-BIN/WEBCGI.EXE/,/?St=582,E=0000000000826410551,K=8457,Sxi=2,Case=obj(217600),VARSET_OBJ=217600,VARSET_TSRC=results,UseTemplate=case.tem,VARSET_TOP=TRUE Just copy and paste this link into the address bar. It's not a schematic, but it identifies what colored wire goes where for the 16-pin connector, ie yellow wire=constant power.
Where do you connect the light blue wire of a xplod stereo?
Light blue is for steering wheel controls or a wire remote control.
A wiring diagram for a Sony cdx-gt65uiw?
A wiring diagram for the Sony CDX-GT65UIW typically includes connections for power, ground, speaker outputs, and antenna. The power wires usually consist of a red wire for ignition (12V) and a yellow wire for battery (constant 12V). Speaker outputs are color-coded, with common colors being gray and gray/black for the front right, white and white/black for the front left, and so on for rear speakers. For accurate installation, always refer to the specific wiring diagram provided in the user manual or on Sony's official website.
How do you put your new Sony stereo in your 1988 Nissan Pulsar?
Take out centre dash, for starters. Remove old unit. then find on the internet the wiring harness diagram to specify what each wire is then match this up with the wires on your sony stereo. hope this helps
How do you wire the front port of a custom case to a Sony VAIO vgc rb50 motherboard?
Please refer to the user manual that came with the motherboard. If this is not possible, please search for "Sony VAIO VGC RB50 Front Panel Connectors" on google images for a diagram.
Ignition coil wire diagram?
The ignition coil wire diagram can be found on Mustangs And Fords website (link to diagram below).
Where does the ATT wire connect on a sony radio?
The ATT (attenuation) wire on a Sony car radio typically connects to the system's remote turn-on lead or can be connected to a compatible device that requires attenuation, such as an amplifier or a hands-free microphone. This wire helps reduce the volume when a call is received or when the audio signal needs to be lowered for clarity. Always refer to the specific wiring diagram for your model to ensure correct connections.
Free 99 Saturn wire diagram?
wich diagram?
