To replace the brake pads on a Toyota Tercel a jack is needed. Some other tools that will be used are a socket wrench, screwdriver, lug wrench, and a pair of pliers.
The 1996 Toyota Tercel brake cable runs from the emergency brake lever to the rear wheel. The emergency brake is on the passenger side rear wheel.
Buy a new one and you will see what all you have to take loose.
don't bother-its not worth the hassle. Or go to a local body shop or the Toyota dealer near you and get their opinion
To replace the brake light on a 1995 Toyota Tercel, first, open the trunk and remove the plastic cover or trim panel on the side where the brake light is located. Then, unscrew the brake light assembly, disconnect the wiring harness, and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring, reassemble the brake light housing, and finally test the new light to ensure it’s working properly.
Lift the car on a jack, remove the tire, brake shoe/caliper, and the old brake pad. Now put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
Underneath the steering column
The 1985 Toyota Tercel brakes are equipped with an adjustment bolt. Turn the adjustment bolt to raise or lower the brake shoe.
Toyato never made Tercels. :P But the Toyota Tercel's brake light switch is located ON the brake pedal just above the viewable area.
It's on the brake pedal just above the viewable area.
To replace the rear brakes on a 1996 Toyota Tercel, start by lifting the rear of the vehicle and securing it on jack stands. Remove the rear wheel, then unbolt the brake drum and slide it off. Inspect the brake shoes and replace them if worn; ensure the springs and hardware are also in good condition. Finally, reassemble the drum, wheel, and lower the vehicle, making sure to pump the brakes before driving to ensure proper function.
To change the front brake pads on a 1989 Toyota Tercel, first, lift the vehicle and remove the front wheels. Then, remove the brake caliper by unscrewing the caliper bolts, and carefully slide the caliper off the rotor. Take out the old brake pads and replace them with new ones, ensuring they are properly seated. Finally, reattach the caliper, tighten the bolts, and reinstall the wheels before lowering the vehicle.
mmmm... still thinking about it