Anything labeled "GM Power Steering fluid" or you can also use dexron II or III Transmission Fluid.
To change the master cylinder on a 1993 Chevy Cheyenne 1500 pickup with a hydraulic clutch, first, disconnect the negative battery terminal. Then, remove the clutch fluid reservoir cap and drain the fluid. Unbolt the master cylinder from the firewall, disconnect the push rod from the clutch pedal, and remove the hydraulic lines. Install the new master cylinder by reversing these steps, ensuring all connections are secure and refill the reservoir with the appropriate hydraulic fluid.
The brake fluid on a 2003 Avalanche goes into the fluid reservoir. The reservoir should be bolted onto the drivers side of the firewall.
At the bottom of the washer fluid reservoir.At the bottom of the washer fluid reservoir.
To add power steering fluid to a Chevy Silverado 1500, first locate the power steering reservoir, which is typically found near the front of the engine compartment on the driver's side. Remove the cap from the reservoir and check the fluid level; if it's low, add the appropriate type of power steering fluid until it reaches the recommended level. Be sure to replace the cap securely after adding fluid. Always consult your owner's manual for specific details regarding your model year.
To change the clutch fluid in a Kawasaki 1500 Drifter, first locate the clutch reservoir and remove its cover. Using a clean syringe or turkey baster, extract the old fluid from the reservoir. Then, refill it with new hydraulic fluid, typically DOT 4 or the manufacturer-recommended type. Finally, bleed the clutch system by loosening the bleeder valve at the clutch actuator while pumping the lever until no air bubbles appear, then tighten the valve and check the fluid level again.
They are hydraulic, self adjusting.
No you can not, There's no adjustment.
DEXTRON II fluid.
type of fluid for 5 speed manual transmission
The first step in removing the window washer fluid reservoir in a Dodge Ram 1500 pickup truck is draining the radiator. Next you will remove the upper hose for better access to the reservoir. Detach the hose and remove the wire harness surrounding the reservoir. Lastly, release the mounting tabs and pull upward on the reservoir.
The abs uses the brake fluid from the regular brake master cylinder.
thru that tube that holds the dipstick.