0
What else can I help you with?
A jumper wire should be used to bridge the electrical ground across?
A jumper wire should use to bridge electrical ground across?
What will happen if you connect your remote wire to the power wire of your amplifier?
Amp always on
A suspension bridge is supported from a height of 30 feet. The length of the wire used to suspend the bridge from the ground to the top is 65 feet. What is the angle of elevation from the base of the?
A suspension bridge is supported from a height of 30 feet. The length of the wire used to suspend the bridge, from the ground to the top, is 65 feet. What is the angle of elevation from the base of the bridge to the point of suspension?
When can a jumper wire be used to bridge electrical ground crossings?
A jumper wire can be used to bridge electrical ground crossings when there is a break in the ground path, leading to unreliable or no connection. By connecting the ground terminals on either side of the break using a jumper wire, you can establish a reliable ground connection and ensure proper functioning of the electrical circuit. It is important to use proper gauge wire and ensure proper insulation to prevent any electrical hazards.
Power akoustik bamf 5500 watt amp powering 2 15 l7s I have checked power wire the ground the remote wire and still can't get amp to turn on the bass remote light turns on but the amp won't?
You may want to check fuses if there are any on your amp, the power wire ground wire and remote wire are the only things i can think of, might want to just ship it back if it is still under warranty. good luck
How do i wire a toggle switch for an amp?
Hook a switch up to the remote turn on and ground. Before the wiring for the amp.
Where is the ground wire for the ignition coil on a 93 C1500 w 5.7?
if you remove the coil cover on top of the distrubutor, there will be a red wire, a white/ or yellow wire, and a black wire which will be the ground. The Coil is not mounted on distributor in 93. It has a remote coil
You hooked your amp properly and it does not work will the remote wire stop the amp from working?
Yes, the remote wire that hooks up to the stereo tells the amp to turn on, it works like a switch. If that is hooked up properly check your ground.
What do you do with the CD player remote wire?
The Remote wire is for the installation of an amplifier. When you install the amp, you have a power (+12V) and ground wire to power the amp, but if you did not have a remote wire, it would drain all of your battery power while you were away from the car (because it would continually suck energy from it); however, without the remote signal coming from the CD player, the amp does not turn on. Does that answer your question? Basically, unless you're installing an amp, don't mess with it.
What will happen to someone who is holding a live wire in the air and not touching the ground?
Nothing will happen , as the current always flows from higher potential to lower potential and if the person is touching only live wire then, there is no other path for the current to flow , but if the person touches the ground , the ground is at "0" potential, so, the current tries to flow from live wire to the ground via person , so the person gets shock in that case but not when a person is only touching the live wire and not the ground.
What would happen if the ground wire was cut off of the grass trimmer or the entension cord?
If the ground wire is cut off from the grass trimmer or extension cord, it can create a safety hazard. The ground wire is designed to protect users from electric shocks by providing a path for the electricity to ground if a fault occurs. Without the ground wire, there is an increased risk of electric shock or device malfunction. It is important to replace or repair the ground wire immediately.
Where do you put the remote wire on your deck?
You only need the remote wire if you have an external amp.
