0
You should turn a Personal Watercraft's (PWC) fuel selector switch to the Reserve position when you notice that the fuel level is low and you want to access the remaining fuel in the reserve tank. This is typically done when the main fuel supply is nearly depleted, allowing you to continue operating the PWC until you can refuel. It's important to monitor fuel levels regularly to avoid running out of gas completely. Always consult your PWC's owner manual for specific guidance on fuel management.
What else can I help you with?
Which position on 750 Shadow fuel selector is RES?
If the bike is between an 1983 to 87 it does not have a reserve switch. It has an idiot light in the dash that tells you when you are on reserve. If it doesn't work you run out of gas.
When should you turn a PWC's Fuel selector switch to reserve position?
well some older jet skis do not have fuel gauges so in that case put the reserve on when it stops going. when the fuel gauge is very close to low it would be good to put the reserve on and get home quickly.
When should you turn a PWC's fuel selector switch to reverse positon?
I believe you mean "Reserve", which is usually a fuel pickup located lower in the tank, to give you some extra gas in the event that you run out in the normal position.
When should you turn on a PWC's fuel selector switch to reserve?
1) When you run out of fuel and need to get back to a dock. 2) When you have a fuel flow problem and suspect the pickup or fuel selector might be clogged and need to get back to a dock.
When do you start to switch gas lever to reserve on your 1981 Yamaha sx400?
Switch to reserve when you run out of gasoline in the normal position.
Does the M4 carbine have a selector switch for full auto AND 3 round burst?
No, it does not. The M4 carbine has a three position selector - Safe - Semi - Burst, while the Diemaco C8 and M4A1 also have a three position selector - Safe - Semi - Auto.
How do adjust a selector switch on a 1994 ford automatic transmission?
To adjust the selector switch on a 1994 Ford automatic transmission, first, ensure the vehicle is in the "Park" position and the ignition is off. Locate the adjustment mechanism, which is typically found near the transmission linkage. Loosen the retaining bolts, align the switch with the proper gear position, and then tighten the bolts securely. Finally, test the selector switch to ensure it functions correctly through all gear positions.
What is the switch on a guitar called?
pickup selector switch
If An engine starts with the automatic transmission gear selector in any position?
That means the switch on the gearbox or lever is stuck for some reason.
What causes a 1990 Sentra not to crank It sometimes starts when jiggling selector in park position?
Defective or out of adjustment neutral safety switch.
Why does the heat come out at the windhield when I switch the dial to come out at the floor in my 2004 blazer?
could be a vacuum leak could be bad selector switch defrost is the default position for this systen
What is wrong with a 2002 Chevrolet Trailblazer that will not come out of 4lo the lights on the switch just flash when you try to change it?
PUT THE GEAR SELECTOR IN THE NEUTRAL POSITION. THEN TRY TO SWITCH IT! GOOD LUCK
