For a 1997 Subaru Outback, the timing belt should typically be replaced every 105,000 miles or every 105 months, whichever comes first. It's crucial to follow this maintenance schedule to prevent potential engine damage due to timing belt failure. Always consult your owner's manual for specific recommendations and consider having the water pump and other related components inspected or replaced at the same time.
Most vehicles recommend changing the timing belt every 60,000 miles.
To replace the water pump on a 1997 Subaru Legacy Outback, first, disconnect the negative battery terminal and drain the coolant. Remove the timing belt cover, then take off the timing belt by loosening the tensioner. Unbolt the water pump from the engine block, clean the mating surfaces, and install the new pump with a new gasket. Reassemble by reversing the steps, ensuring all components are properly aligned and tensioned.
check this link, it did helped me get info on my 97 subaru outback. http://hp.auto.ru/Subaru%20Legacy/1997/ cheers!
It should be.
Throttle position sensor on this vehicle is held on by two screws. It's a 10 minute job.
You can pull the motor or thetransmission, though the trans is easier. But if you need to ask you should probably take it to a shop.
225/60/16
Your question is a little vague but I think I understand what you are asking. There are white marks on the edge of the timing belt and white marks on the pulleys. Align those and you are all set.
You have to remove the console cover. This starts with two screws in the console storage tray.
From 1995 to 1999.....
According to my repair manual the refrigerant is HFC134a.
Check your thermometer and if that's not it...head gaskets.