0
What else can I help you with?
Why do your tail lights smoke when you hook up the battery?
Dead short to ground
How do you insall a amplifier?
hook a ground up to your battery and mount it to the amp and hook it up with a few more things and yea you got it man
When you hook up the battery on your 87 RX7 you get no power what could cause this?
you could have a bad ground wire that was my problem
How do you hook up a 1990 ford f150 battery?
Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.
Proper hook up of jumper cables to a semi truck?
Depends on what year it's from. On an older truck, hook the positive to a positive battery post, hook the ground to a bolt which goes through the chassis. On a newer truck, which is apt to having chassis-mounted electronics, put the ground to the negative battery terminal.
Where do jumper cables hook up to on the 96 Aurora?
Positive is connected to the positive terminal on the battery and negative is connected to a ground point on the engine away form the battery. Under the Hood, on the passengers side, is a positive terminal with a red plastic cover. Put your ground on a metal part of the engine. No need to pull up the back seat to hook to the battery.
What battery wire to you hook up first in a car battery?
Hook positive up first, negative last.
How do you turn a head unit on without a car?
Get a charged 12 volt battery hook 12 volt constant/RED to the + on the battery then ground - it should power up.
How do jump start a dodge charger?
There should be a positive battery cable hook-up under the hood and take the ground on the cables and hook to engine block or some metal piece.
How do you charge the battery of an equinox?
Hook up a battery charger to it.
How do you wire a rocker switch to radiator fan on a Grand Am?
to shut the fans on and off by yourself. remove the connector for the wires at the fan. hook a wire from the positive on fan motor to the inside toggle switch, do not hook to switch yet. run a wire from the positive on battery, hook to battery after hooking up switch. hook up the wires to the switch. then the battery. its up to you if you want to install a 15 amp fuse in line from battery to toggle switch.. you can also get the power from the fuse box instead of the battery. this should work for you. if not you may need to ground the other fan wire.
How do you hook up a 6 volt positive ground ignition coil on a 1949 ford tractor?
To hook up a 6-volt positive ground ignition coil on a 1949 Ford tractor, first ensure the tractor's battery is disconnected. Connect the positive terminal of the coil to the ignition switch, and the negative terminal to the distributor. Make sure the battery's positive terminal is connected to the chassis ground, as the system operates on positive ground. Finally, reconnect the battery and check for proper spark when cranking the engine.
