The fuel cutoff switch in a Peugeot 307 is typically located in the passenger compartment, often near the driver's side footwell or under the dashboard. It's designed to disconnect the fuel pump in the event of an accident. To access it, you may need to remove a panel or cover. Always consult the vehicle’s owner manual for the exact location and instructions.
Because I don't maintain it properly.
ONE so ive searched out!
were do i find the fuel filter on a peugeot 307 1.6 petrol
The Peugeot 307 has several warning light symbols with different meanings. The oil can symbol means an oil change is needed while the exclamation point means the tire pressure is low.
The way that a person would release the spare wheel on a Peugeot 307 when the release handle comes off is not available. It is best to contact a dealer or a mechanic for further information.
In a Peugeot 307 CC, the fuel cut-off switch, also known as the inertia switch, is typically located in the passenger compartment, near the driver's side footwell or behind a panel. It may be found on the right side of the dashboard or under the steering column. If you need to reset the switch after an accident or fuel system issue, simply press the button on the top of the switch. Always refer to your vehicle's manual for the exact location and instructions.
No load: Front: 2.5bar Rear: 2.5bar Max load: Front: 2.5bar Rear: 3.2bar
The fuse for the left brake light is # 5 and the right and 3rd brake light fuse is # 17 in the fascia fuse box
Peugeot 307 fog light switch, is a ring located on same lever used to activate direction light. According Peugeot 307 equipment, it could have rear and front or just rear fog light
In order to change the brake light switch in a Peugeot 307, you must dismantle and access the main light board on the dash and find the connecting switch, thusly flipping it back to the on position.
It is a plunger type switch screwed into the top of the transmission casing.
Its all electronics. Either turn your fuel pump off manually by cutting power supply. In practice, when you turn switch off, hdi pump and injectors stop as well. There is no mechanical valve.