Top of the brake pedal.
Stop light switch? Most are located at the upper end of the brake pedal under dash area
Usually on the upper end of the brake pedal under dash area
On the brake pedal arm.
Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.
It is mounted on a bracket under the dash at the brake pedal. From there it is self explanatory.
With an ohmeter or a self-powered test light. Hook the two leads of your tester to the terminals on the brake light switch. Push down on the brake pedal and if the light stays off or the meter stays at infinity, the switch is bad.
This happened to my 1985 Lebaron Conv and all the car needs is a new brake light switch mounted on the brake pedal under the dash. Problem solved!
Check bulbs Fuse Stop light switch
The brake master cylinder on a 1985 Nissan 300ZX is located on the driver's side of the engine bay, mounted on the firewall. It is typically found near the back of the engine compartment, close to the brake booster. The master cylinder is connected to the brake lines and is responsible for supplying hydraulic pressure to the braking system.
the brake light fuse is located where the brake pedal is at... just take the cover that it has above the brake pedal and you're gonna see fuses on your left....
Turn signal stalk.
Chrysler does not use inertia switches.