answersLogoWhite

0

With an ohmeter or a self-powered test light. Hook the two leads of your tester to the terminals on the brake light switch. Push down on the brake pedal and if the light stays off or the meter stays at infinity, the switch is bad.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the brake light switch in a 1985 ford cown Victoria?

On the brake pedal arm.


1985 bronco brake lights dont work but all other lights do work you replaced brake light switch and bulbs?

Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.


How do you find the brake switch om a 1985 sports van?

Stop light switch? Most are located at the upper end of the brake pedal under dash area


How do you change the brake light switch on 1985 Chevrolet Impala?

It is mounted on a bracket under the dash at the brake pedal. From there it is self explanatory.


Where is brake light switch located on Chevrolet 1985 g20 van?

Usually on the upper end of the brake pedal under dash area


Why would the brake lights on a 1985 Toyota Camry quit working?

Check bulbs Fuse Stop light switch


Where is the brake switch located on a 1985 peterbuilt B?

Top of the brake pedal.


Why would the brake lights on a 1985 LeBaron not work even though the tail lights work fine?

This happened to my 1985 Lebaron Conv and all the car needs is a new brake light switch mounted on the brake pedal under the dash. Problem solved!


How do you switch out ignition switch on a 1985 c10 Chevy pickup 4x4?

Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


BMW E30 1985 318 brake warning light not brake pads light is constantly on although the brake fluid level is OK?

Check the sensor in the brake reservoir give the float a wiggle. Use a multimeter if necessary if constant low reding is given the switch /sensor is no good.


When did cadillac introduce the third brake light?

1985


How do you remove a 1985 Chevy El Camino Ignition switch?

The 1985 Chevrolet El Camino ignition switch can be removed by loosening the retaining ring at the top of the switch. The switch will slide out. Remove the wiring harness from the back of the ignition switch.