In a 1993 Chrysler Acclaim, the coolant temperature sensor is typically located near the thermostat housing on the engine block. It is usually positioned on the intake manifold or cylinder head, depending on the engine variant. This sensor monitors the engine's coolant temperature and sends the information to the engine control unit (ECU) to help regulate engine performance and emissions. Always refer to a repair manual for specific details and locations for your vehicle model.
There is a coolant temperature sensor and a temperature gauge sensor. the coolant sensor is located on driver side of the cylinder head. screws right into it, and the temperature gauge sensor is on the front side of the cylinder head right under the distributor. hope this helps
its on the drivers side head.
On a 1993 Geo Tracker, the coolant temperature sensor is typically located near the thermostat housing on the engine block. It is usually situated on the cylinder head or intake manifold, depending on the engine configuration. To access it, you may need to remove any obstructing components, such as the air intake or engine covers. Always ensure the engine is cool before attempting to locate or replace the sensor.
Is it the Oil Sending Unit or as some people likes to call it the Oil Pressure Switch...
The temperature sensor on a 93 Olds Cutlass Cierra 3.3 is located on the back of the engine. It is on the intake manifold.
The 1993 Chevy S 10 Blazer 4.3 liter engine temperature sensor can be grounded to the engine block. You can use the temperature sensor retaining bolts to ground the temperature sensor.
The Coolant Temperature Sensor on a 1993 & 1994 Buick LeSabre is located on driver's side of the car under the throttle body, It is screwed into the lower intake manifold. You cannot see it without first removing the throttle body since it is hidden under it. An electronic plug is clipped to the the end of the CTS.
In a 1993 Volvo 940, the block temperature sensor is typically located on the engine block, near the thermostat housing. It can be found on the driver's side of the engine, often near the cylinder head. This sensor monitors the engine's coolant temperature and sends the information to the gauge on the dashboard. If you're having trouble locating it, consult your vehicle's repair manual for a detailed diagram.
The IAT intake air temperature sensor plug on a 93 Nissan is on the intake pipe. The EGR sensor is located on the intake manifold.
I had one do that and it turned out to be the coolant temp sensor next to the thermostat was bad.
its in the radiator on the passanger side up twords the top its a little square box
temperature sensor for this car is located on a heater hose on the drivers side near the battery and under the black air intake tube