answersLogoWhite

0

The 1992 Ford F1 50 pickup truck 4.9 liter engine crankshaft sensor can be found on the back of the engine. You will to remove the rear engine cover in order to access the sensor.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the crank angle sensor on a 92 eclipse?

the cam angle sensor is the crank angle sensor it preforms both jobs


You put a new crank sensor in your 92 Buick and now its like its out of time?

You put a new crank sensor in your 92 buick and now its like its out of time?


If a 92 Jeep Cherokee will crank over but will not start what is the problem?

probably crank sensor, they are famous for that


Where is the crank sensor on a 92 150 dodge truck 318?

The "crank" sensor is the pickup plate under the distributor cap.The "crank" sensor is the pickup plate under the distributor cap.


Will 92 park avenue start with bad cam sensor?

No it will not start need to change the cam sensor & crank sensor!


92 ford ranger has no spark new module crank sensor?

its junk! crush it!


Where is the crank sensor located on a 92 Ford Tempo?

The 92 tempo doesn't have a crankshaft sensor. However the multi-port fuel injected models do have a Camshaft Position Sensor located near the distributor.


Why won't your 92 Lexus sc400 crank over?

If you mean won't start, check the cam and or crank sensor. If it won't actually crank then something is broke inside or just seized.


WHERE crank sensor 92 olds achieva?

It is located behind the harmonic balancer, also called the vibration dampener.


Where is the crank sensor located on a '92 Saturn SL?

Hey Kevin==It depends on your engine but I think it is on the fromt by the balancer. GoodluckJoe the crank sensor is on the back of the block above the starter motor It has a green 2-wire connector to it.


Where is the crank sensor on a 92 Chevy Cavalier 4-cylinder 2.2L?

The crank sensor is located on the back engine wall in the middle, just under the two coil packs (from where the spark plug wires come). There is a wire harness from the crank sensor to the module which holds the two coil pack. The crank sensor is held into the engine by a single bolt. To see all of this, you have to go under the car. I am having an intermittent no start problem with my 93 Cavalier (it cranks, but no spark at all) and I think the crank sensor is my problem.


Why did your 92 Chevy Corsica suddenly stall and never start again?

Could be your crank sensor. These are very common to fail on these cars.

Trending Questions
1988 ford f-150 check engine light is on with codes 98 63 will not idle but highway driving ok what now? How do you set timing on hei engine? What is the stock tire size for a 1994 Chevy truck? What does the engine service light on a Nissan Maxima mean? How do you replace the serpentine belt on a 2001 Suzuki Vitara 4cyl? Can someone help me out i have a 2003 dodge ram 1500 two wheel drive and when i turn the steering wheel i hear a grinding noise as i am driving down the road? When you disconnect the battery on your 1997 Dodge Grand Caravan the air conditioner buttons blink whats wrong with it? Why is it on a 1997 ford f'150 only hot air no matter what the controls are set on and only air out of the defrost? How you hook the front brake squealer to brake pads? Why is it that my brand new car has a burning smell and tapping noise in the engine? When coolant warning light on coolant anti-freeze added Seems to be leaking water added but engine still over-heating Heck do i need a new radiator and how much will this cost for a 1998 peugeot 106? How do you replace belt on indesit dryer? Cigar lighter does not work? How much horsepower does a 305cc Briggs and stratton snowblower engine have? What is the acc wire? How do you replace cigarette lighter bulb on 2002 Toyota 4runner? Who makes Value Craft oil filters? What are the carb adjustment screw settings for an 82 Chevrolet Scottsdale with a two barrel on a 350? Where is the oil filter on 2005 dodge magnum 3.5l? Location of the transmission on a 2008 Volvo semi with a Cummins engine cant find where to ut the fluid in at?