0
In a typical circuit setup, the resistor can be placed on either the positive or negative leg, depending on the configuration and purpose of the circuit. However, the orientation of the resistor does not affect its function, as it is a passive component that limits current flow regardless of its position. Always ensure that the resistor's value is appropriate for the circuit to avoid damaging components.
What else can I help you with?
Converting from points to electronic ignition are the wires connected pos to pos or pos to neg on 305 Chevy on coil?
remove resistor from loop positive to positive terminal neg to neg
How do you reset the computer on a 95 eagle talon?
Disconnect the neg. side and then the pos side of battery. Then to completely drain the power press brakes or press horn. Wait fifteen minutes and reconnect pos side then neg. side of battery.
How many oxygen sensors has a Toyota Sequoia?
The Sequoia has four oxygen sensors, two on each side. The ones in front of catalytic are pos 1 and after are pos 2. Bank 2 is on passenger side, Bank 1 is on the driver's side.
Which side is the primary side of a coil?
Both of the small posts (pos & neg) are primaries. The large connection is the secondary.
Where is 94 ford 7.3 throttle pos sensor location?
On a 94 Ford 7.3, the throttle POS sensor is on the throttle body. It is on the opposite side of the throttle linkage.
Why do you have only 6 volts at positive side of coil on 1987 w250?
The resister cuts the voltage to 6v.. in run pos,Will send 12v to coil in start pos.
How can you wire 2 12inch pioneer subs dvc 4ohms 1000 watts max to 2 pioneer 760 watt amps both amps are 2 channel they can be bridged?
You do pos to one side to pos the other side on the sub then the same for negative then to the amp you hook the pos to one channel then the negative to the other channel and the same on the other sub and amp
How safe is the Pos-T-Vac in treating erectile dysfunction?
"Pos T Vac, otherwise known as vacuum therapy, can be used alone or in conjunction with oral medications such as Viagra. It is FDA approved, and no harmful side effects have been documented in the use of the Pos T Vac."
How do you bridge a two channel amplifier?
hook both pos on one side and both neg on tha other
How do you know if your blower motor is bad or if you need to just change the resistor?
Use a jumper wire from the battery + (pos) terminal to the positive on the blower motor, and run a - (Ground) wire from ground on the motor, to chassis or frame.
Can a child have a different blood type from the father?
My Mother was O pos. Dad was AB pos. Can I have a different blood type such as A pos? My siblings have AB pos.
Where is crank pos sensor on dodge 318 gasoline engine?
Behind the passenger side head in the top of the bell housing.
