After correcting what the initial problem that caused the light to come on, I was able to disconnect the negative terminal of the battery for about 1-2 minutes and the light went away. I hope this helps... "01" Mazda Tribute 3.0L V6
Yes it is an interference engine
in the bonet
Check the fluid level in the master cylinder.
The bank 2 is located on the driver side of the engine on the Mazda Tribute. The Sensor 2 is located after the catalytic converter.
turn ignition to poss 2, then hold down button for trip meter for about 15 seconds.. start engine, engine management light should go off...
To reset the engine management light on a Citroen Picasso, press and hold the trip reset button. Turn ignition key to position 2. By keeping the button pressed in, the trip meter will count down. When zero is reached, release the trip button and the start car service light will be extinguished.
The '01 Mazda MPV with the 2.5 Liter engine actually has two timing chains, one for each side of the V6 engine. This engine has 2 overhead cams on each side of the engine (DOHC) controlled by the 2 chains.
To reset the check engine light on a 2005 Mazda 2 after an oil change, you can use an OBD-II scanner to clear the error codes. Simply connect the scanner to the vehicle's OBD-II port, turn on the ignition, and select the option to clear the codes. Alternatively, you can disconnect the negative battery terminal for about 15 minutes to reset the system. Always ensure that any underlying issues are resolved before resetting the light.
Trouble code P0138 means:O2 sensor circuit high voltage (Bank 1 Sensor 2)
1) fuel tank very low apporaching empty. 2) Engine's electrical system has a problem. 3) the emission control system has a problem. 4) The filler cap is missing or not tightened securely.
Knowing the firing order of a car's engine can help with engine issues later. The firing order for a 1995 Mazda Miata is 1-3-4-2.