0
A noise in the GMC Yukon steering column could be due to several factors, including worn or damaged components such as the steering gear, universal joints, or bearings. Additionally, issues with the Power Steering system, such as low fluid levels or a failing pump, can contribute to unusual sounds. Loose or damaged parts within the steering column itself may also be a source of noise. It's advisable to have a qualified mechanic inspect the vehicle to identify and address the specific cause.
What else can I help you with?
What would cause a ticking noise coming from the dashboard of a 1997 GMC Yukon near the steering wheel?
relay
Where to find a steering column diagram for a GMC truck?
Where to find a steering column diagram for a GMC truck?
What is the clunking noise under the hood and felt in the steering wheel of a 2005 gmc Yukon XL?
It's your upper steering shaft. Either take it off and grease or replace it.
What causes a 2001 GMC Yukon power steering make a whining noise?
Could be low on P/S fluid and/or has air in the P/S system.
Instructions to adjust the shifting cable on the steering column of a 1993 GMC Van 1500?
How to adjust the linkage on cable from steering column to transmission on a 1995 GMC Van?
Where is the horn located in a 2007 gmc Yukon?
it is located on the steering wheel.
Where can you find a steering column diagram for a 1989 GMC Jimmy?
You can find a steering column. Diagram, for a 1989 GMC Jimmy, at most GMC dealerships. You can also find the diagram at most auto-parts stores.
Gmc 1500 sierra that i have already taken to the dealership with some noise in the steering column it was the rr steering shaft that was inadequately lubed should i have them replace the shaft?
There is a recall on that item, they should fix it free.
Do you have to remove the steering wheel to remove the column on a 2003 GMC sierra?
No. You can remove the entire column with the steering wheel still attached.
1988 gmc safari Steering column switches and ignition key lock cylinder replacement?
1988 gmc safari Steering column switches and ignition key lock cylinder replacement?
Why does my 2001 GMC Yukon make a clunking noise in the front end?
My 2003 GMC Yukon XL had the same problem after two years. The dealer said a slip shaft in the steering was manufactured with loose tolerances. May have been part of a recall or a service bulletin at one point. They packed it with grease. Have not had a problem since.
Where is the ecm on a 1995 gmc Yukon?
On a 1995 GMC Yukon, the Engine Control Module (ECM) is typically located under the dashboard on the driver's side, near the steering column. It may be mounted on the firewall or in the area behind the glove compartment. Accessing it may require removing some trim panels or the glove box for better visibility.
