0
checked if the display on your odometer says trip a, if not then set it to trip a, then turn off the ignition, then press the odometer reset button, and turn ignition to the on position, you will see 5 blinking dashes that will disappear one by one, hold this position until you see the display go back to the numbers read at trip a, otherwise if you press a little longer it will clear the mileage indicated.
What else can I help you with?
How do you reset the Maint required light on a 2008 Chevy Colorado?
read your owners manual
How do you reset the maint reqd light on 2008 Corolla?
To reset the "Maint Reqd" light on a 2008 Toyota Corolla, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the light should turn off, indicating that the maintenance reminder has been reset. If it doesn't reset, repeat the steps to ensure they are done correctly.
How do you reset the airbag light in the 2008 Scion xD and why is it on?
You have a defective airbag. You replace that bag.
How do you reset your battery light on a 2008 scion xb?
To reset the battery light on a 2008 Scion XB, first ensure that the battery and charging system are functioning properly. Disconnect the negative battery terminal and wait for about 15 minutes before reconnecting it. This should reset the battery light. If the light remains on, there may be an underlying issue with the battery or alternator that needs to be addressed.
How do you reset the service light in a 2008 scion xd?
To reset the service light in a 2008 Scion xD, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. Start the engine to ensure the service light has been reset successfully. If the light remains on, repeat the process.
Where is the maint reset button on a 2008 corolla?
Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla
How do you turn off a maint reqd light and the exclamation point light off of a Toyota matrix 2008?
Hold down the "trip reset" button with the ignition off and keep it pressed while you turn the ignition on
How do you set tire pressure light on 2008 scion?
To reset the tire pressure light on a 2008 Scion, first ensure that all tires are inflated to the recommended pressure. Then, turn the ignition to the "ON" position (without starting the engine). Press and hold the tire pressure warning reset button, usually located under the steering wheel or on the dashboard, until the light blinks and then turns off. Finally, turn off the ignition and start the vehicle to confirm that the light is no longer illuminated.
Toyota rav 4 maint required light 2008?
http://wiki.answers.com/Q/Toyota_rav_4_maint_required_light_2008"
How do you reset 2008 Honda Element service light?
How do you reset 2008 honda element service light?
How do you reset engine light in 2008 buick lucerne?
how do you reset check engine light in 2008 buick lucerne
How do reset t-belt light cruiser 2008?
Hi I have cruiser 2008 gxr how is reset t.belt light
