0
What else can I help you with?
You replaced brake switch lights still on?
Check the petal and make sure that the plastic part that touches the brake light switch when the petal is in contact with the brake light switch is still on the petal, if it is missing you will need to replace it, so the petal will make correct contact with the brake light switch.
What could cause your brake petal to feel soft?
Air in the brake lines
Adjust parking brake?
how do you adjust parking brake
How to Adjust emergency brake 2001 frontier?
how to adjust the emergency brake
What does it mean when you push the brake petal and the car revs up on a 1990 Crx?
The Brake booster needs replaced
Brake petal low after installing big brake kit?
bleed your brakes again...there's air in the lines
When you push your brake petal on your 95jeep grand Cherokee it sounds like air and the petal is soft?
You need to inspect the brake pads/shoes and have the brake system bled. The soft pedal is air in the brake system. The fact that you are hearing air makes me suspect you may have a defective brake booster. Have the power brake booster vacuum diaphragm inspected.
How do you adjust the the brake on a mobility scooter?
How do I adjust the brake on a pride maxama scooter.
How do you adjust the parking brake on a 1995 Mazda 626?
The majority of time if you adjust the rear brakes it will adjust the park brake.
How to bleed the brake system on 1991 Chevrolet truck?
1) Con a helper into helping you. 2) Open the bleeder valve on the brake cylinder. 3) Have your helper press on the brake petal. 4) Close the bleeder valve when air stops or when the petal is floored. 5) Have your helper release the brake the petal. 6) Check the fluid level in the master cylinder. If it goes dry you will have to start all over. 7) Repeat 2-7 until you stop getting air from the brake system.
What can stop brake lights from coming on when you push down on brake petal?
Only if the bulb or wire is burnt out... Else the switch has defect,,
Why is the brake petal soft after you change the brake pads?
This is caused by the pressure release in the brake lines when you retract the pistons in the brake calipers to accommodate the new brake pads that are thicker than the ones that are removed.
